3s-gte camry swap mount?

[LoCuTuS]

my cousin help my for traduction,...
Hello again ,
My question is regarding the engine support front and back , my installation was with the original (5sfe) support now due to many breaks of transmission I bought a camry v6 92 standard shift to use the transmission support. I would like to know if I can use the front support v6 on the 3sgte without modifying anything . I would also like to know the procedure to follow to install the rear support ,must I change the axle shaft or move the bearing ? I need clear details cause I would like to install the engine for the last time!
I also need some advice concerning my engine due to breakage 3 times I damaged the area where I screw the rear support …I have a couple of pictures I would like to know if I haftoo change the block or if its salvageable !?!

[Rdizzle]

post up pics man

And more of your car, its pretty nice

[LoCuTuS]

[LoCuTuS]

[LoCuTuS]

i have problem to send picture got to:http://locutus.monchar.com/

[LoCuTuS]

For the picture of the engine I can only sent by e-mail it's too big space
send my email to warningtime@hotmail.com after i send the pic

[Eye8Pussies]

well, here is the question...

what did you do to make the 5sfe rear tranny mount fit?

as for the axle, you can re-use the 3vz 5-speed one that came with your car....as well, I would presume that the bearing can be reused as well....it would be the actual mount itself, from the 3sgte that would not be able to bolt onto the camry subframe- be it that it's out of position, too small, too big, or the wrong shape