Hey guys i have 3 12" dvc 6 ohm subs please give advice

[Camryv6xle]

Hey guys i have three 12" ma audio ma120g6 subwoofers with 6 ohm dvc, 400rms and 800watts max and need some advice.

is it possible to wire these to 2 ohms?








also what kind of amp would i need to power these? i was thinking of getting an amp with 1200 watts rms at 4 ohms but i have no idea. mono? bridged? ahh!

i had a previous pyle amp and was pleased with its quality and this one is the same as my old one but 2400 watts but it doesnt say its rms

http://cgi.ebay.com/NEW-2400-WATT-2-...QQcmdZViewItem

this one is 1200 watts rms but doesnt say max ftw??
http://cgi.ebay.com/ebaymotors/1200-...spagenameZWDVW

[touringcamry]

Arc Audio SE 2300

If you take one voice coil from each sub and wire them parallel to each other then wire the other voice coil similarly, you will have two 2 ohm loads which you can then use as 1 ohm or 4 ohm loads when you put those two 2 ohm loads together.

The Arc Audio SE2300 will put out 1300W RMS @ 4 ohms so you'd get at least 433W per sub since Arc amps are under rated.