Some good and some bad

[MyFreeCamry]

First pics of a little bit more detail for a battery relocation. Have had a lot of questions and the weather is finally better for me to take some, so here ya go.

Ground location



Power going from trunk under rear seat on driver side


Location of where I had to drill hole


Running through engine bar on driver side



Any more questions just feel free to ask.

Now my mass aray of parts that are awaiting to go on







Now I have been put back even further from my install weekend due to the fact that someone or somebodies are trying to either hurt or kill me. Last week while getting some food on lunch, the car develops a nice thumping and shaking problem. As I was pulling over to check it out, my driver front hits the ground and the wheels keeps on going. So needless to say somebody loosened my lugs on me either at work or the night before. Without going any further I now have to replace my brand new driver lower control arm with another, brake rotor and fender. So far my luck this year has been nothing but bad. Oh well, I'm letting it roll of my shoulder and wake up each day to a new day.

[Red_T_SwiftCam]

Hey thanks Free. This gives me some ideas.

Sorry to hear, hope things stop.

[ghettosled]

looks good, though i would suggest installing a grommet where the power line passes through the firewall. thin metal, slight burr and vibrations will take a toll on the wire shroud.

[MyFreeCamry]

I am actually replacing that wire when I put on the rest of the stuff. The actual copper core is not thick enough for my liking. But when that happens yes deffinently will be getting a grommet, didn't have any at the time but I do now.

[bigbird]

nice man...id prollyu try to wrap that in a wire loom to protect it a little more though. looks liek ya have alot of fun ahead of ya.

well if someone is sabotaging your ride and if ya figure out whos doin it i suggest severing a limb or 2...so they never forget but cant get revenge...at very least leave a scar.