for all the peolpe who have done the v6 manual swap

[blackhawk]

every thing came out of a 2000 solara

in the car already driving around master cylinder pedal hand brake conversion working.
the other things i have are tranny with mount, plate, slave cylinder flywheel clutch with all bolts.
on to my question before i drop the tranny i want to know if the outer part of the axle would fit .... this .... i don't want to start it and have to leave it i want to get it done in one shot.
i also have to get the resisters
and also before i go if i do get the outer part from the junk yard would i run in to any other problem such and the brakes not matching up ill take pictures of what i have in and out of the car ..... also any tips trick ill share mine also......

[bigbird]

cant help ya man but good to see ya still around.

[RichieRichJP]

Originally Posted by blackhawk

every thing came out of a 2000 solara

in the car already driving around master cylinder pedal hand brake conversion working.
the other things i have are tranny with mount, plate, slave cylinder flywheel clutch with all bolts.
on to my question before i drop the tranny i want to know if the outer part of the axle would fit .... this .... i don't want to start it and have to leave it i want to get it done in one shot.
i also have to get the resisters
and also before i go if i do get the outer part from the junk yard would i run in to any other problem such and the brakes not matching up ill take pictures of what i have in and out of the car ..... also any tips trick ill share mine also......

Yes they will. You shouldn't have any problems with anything. Have fun getting the carrier mount to fit

[blackhawk]

yah man i just been tying to finish school .... ran into so probs but now am back and trying to do this swap finally after years on running around....

any one else can confirm this .... i had asked the junk yard and they said the computer says no but i just want to ask you guys i feel know more than them.....

[RichieRichJP]

Dude, I completed the swap already, that's enough confirmation lol

[blackhawk]

lmao okay thank i really appreciate it .... i just don't want to run into any problem and did you run the black with white strip and black wire to the clutch pedal reason why i ask is because am not shore where the wires should go on the bottom or on the top their seem to be two different switches on the pedal it self thanks in advance

[RichieRichJP]

You're using the 5sfe wheel bearing or the Solara one?
People here said that they were the same size...

[blackhawk]

i think you read the post wrong or misunderstood what i was asking i have am "1mz" v6 94 camry coupe and the tranny and full axles are from a 2000 solara ... i wanted to know if they will fit just cus i don't want to pull shit apart and get stuck ....

[RichieRichJP]

oh you have a 1mz...
better ask someone else!

[blackhawk]

haha yah it okay i wen to the junk yard today and they seem to fit i it did not go in all the way which they said and i saw was due to rust and i feel when the bolt goes on it will be fine .... it would not go in at all if the pins were different right cus they would not line up ?

[RichieRichJP]

If the grooves didn't line up, it should go in at all

[blackhawk]

okay cool good looks where is king and adam when you need them lol prob grooving on the beach with some coronas lol

[blackhawk]

okay so i pulled the car apart today and the axle wont go all the way in the hub should i worry or just pin it .... the part that is a little out is the abs part i do i need to worry ???? please help some one who have done this