Best rear floor mat 94 camry sedan?

[Puppu]

I been looking around for some all weather rubberised kinda mats for my car but I can't seem to find any that cover the whole rear area. I have looked at husky and weathertech but I really want a mat that goes the whole way across not 2 pieces in front of each passenger.
I am sure i am just missing something really obvious and its right there in front of me but any help pointing me in the right direction would be great.
J

[LynchburgCSI]

To be honest, I've never seen a floor mat that covers the AWD drive shaft hump. Hmmm. Subscribed.

[Tom 2000]

I don't have a pic, but what I did was to buy 1 small really cheap rubber rear floor mat in the same color, cut a notch to fit around the center console and it sits on the center hump like a horseblanket.

[Puppu]

I expect to probably have to do the same and cut up a cheap mat but i was really hoping that I didn't have to.
What about companys who will re upholster the interior? Someone who could rubberise the whole interior and make it dog proof?
Suggestions?

[iovaykind]

If you want to go custom, then I'm sure some local shops would do it for you.. depends on how much you want to pay. But I know there's no cover that goes over the hump.. I tried looking for it before and had no luck

[LynchburgCSI]

Originally Posted by Puppu

I expect to probably have to do the same and cut up a cheap mat but i was really hoping that I didn't have to.
What about companys who will re upholster the interior? Someone who could rubberise the whole interior and make it dog proof?
Suggestions?

Two words man; LOCAL SHOPS. Go to a local mom and pop upolestry place and sit down and discuss what you want to do and what your willing to spend. My guess is that a lot of stuff would get vinyl covered.

[jtex2717]

Originally Posted by LynchburgCSI

To be honest, I've never seen a floor mat that covers the AWD drive shaft hump. Hmmm. Subscribed.

AWD ......not to thread jack....but do tell more!

Are you saying there is an AWD Gen 3 out there and NO ONE has done this conversion yet???

[Puppu]

If i do go custom then what is fair amount to pay? I come from the UK where everything is expensive, it would be easy for them to rip me off as I would not know what would be a fair amount

[LynchburgCSI]

Originally Posted by jtex2717

AWD ......not to thread jack....but do tell more!

Are you saying there is an AWD Gen 3 out there and NO ONE has done this conversion yet???

Long story short... yes it's possible to do a swap to AWD. The JDM camry (scepter) came with AWD from the factory.

/threadjack.

Originally Posted by Puppu

If i do go custom then what is fair amount to pay? I come from the UK where everything is expensive, it would be easy for them to rip me off as I would not know what would be a fair amount

Depends on what you want done! What did you have in mind as a solution?

edit: rule of thumb.... $2.00 USD = 1.00 Euro.