1996 Toyota Camry ECU Pinout needed - Toyota Nation Forum : Toyota Car and Truck Forums

RichieRichJP · 05-10-2011, 12:36 PM

As topic says. This would be for the MANUAL transmission. I don't have the owners manual...
I need to know the pinout in order for me to wire the reverse lights back in.
I can also use this information for the 5SGTE build thread for you guys.

rusty9 · 05-10-2011, 08:07 PM

I dont think the reverse lights are tied into the ECU in anyway. the switch is physically on the tranny right?

i know i've posted this before...

RichieRichJP · 05-10-2011, 10:29 PM

Quote:

Originally Posted by rusty9

I dont think the reverse lights are tied into the ECU in anyway. the switch is physically on the tranny right?

i know i've posted this before...

Yes, that's a very familiar diagram. Thanks!
I wasn't entirely sure if it was tied to the ECU, but to answer your question, that switch is located on the top center of the tranny. My assumption as the MR2 wiring harness is set up where the wire is in the engine harness but may be in a way that I think may not actually reach the ECU.

I'll pass this over to my dad, I don't know exactly how to read these.