Hey all! havent posted in a while but i have a new set of HID's to install this weekend and I want to remedy what may be a bent frame/housing that has been messing with the aim of my headlights. I'll try to throw a few pics of the pattern up later to explain but in the mean time I'm just looking for some suggestions. The driver side housing has been ained lower than it's passenger counterpart and the adjustment screws dont seem to make any noticeable adjustment. I was thinking about shimming the bolts to adjust but not sure if there are any other opssibilities. I was backed into last year
causing minimal damage other than some paint transfer and a cracked housing but they have since been replaced with clears and now just need to aim properly. I hope this makes sense and any help is greatly appreciated. Thx!!
Headlight housing/frame might be bent....
Linear Mode
