Wiring & coil drivers 4 cly 97

[Davee]

Found some decent wiring help on Bulldog security site . Are there two "ignition wires " in igntion harness because of two coils on 97 4 cylinder? Working to install Can tire Prostart remote starter . Will post once all sorted out I suspect I need to provide Ignition output from remote package to both coils

[88 LE]

There is 2 ignition wires, but its not because of 2 coils.

12V: White - white/red
Starter: Black/white
Ignition: Black/yellow
Second Ignition: Black/orange
Accessory: Pink/blue

All the wires listed above are at the ignition harness.

[Davee]

Originally Posted by 88 LE

There is 2 ignition wires, but its not because of 2 coils.

12V: White - white/red
Starter: Black/white
Ignition: Black/yellow
Second Ignition: Black/orange
Accessory: Pink/blue

All the wires listed above are at the ignition harness.

The bulldog site lists ignitions as Black/Yellow & Black/Red so I will watch for Black/Orange now too Thanks! Also had no previous refence for the Accessories
My question perhaps should have been what do the two wires do -- So I can sort out if I need to attach two remote starter output relays . I would assume so but trying to be careful. A lot will be revealed when I test the various wires to confirm the colours are right
Will post once I get it working -- Likely in week after New Years Have a good one

[88 LE]

Originally Posted by Davee

My question perhaps should have been what do the two wires do -- So I can sort out if I need to attach two remote starter output relays.

Ignition is for the starting stuff (clutch safety switch, neutral safety switch, starter, etc..)

Second ignition is for: coil, ignitor, ecu

[Davee]

Originally Posted by 88 LE

Ignition is for the starting stuff (clutch safety switch, neutral safety switch, starter, etc..)

Second ignition is for: coil, ignitor, ecu

Great help I will post the wiring check results for others once I get into it.
Now I know I have to provide outputs to both wires as I expected

Dave