Gen 6 lip on gen 5

[cntower]

I searche4d everywhere I could but couldn't find any info on this. Probably due to the search terms throwing up too much of a range in matches, anyway...

Here's the question. Does anyone know if the gen 6 camry lip (front back side skirts) Example here in picture : http://commons.wikimedia.org/wiki/Fi...h_gen_rear.JPG will fit onto a gen 5 camry?

Now I know this isn't a direct fit piece, what I'm asking is does the overal dimensions of the gen6 camry lip conform to the overall dimensions of the rear bumper on the gen5 camry. Or would it come up 1 or 2 inches short at the wheelwells if held up against the gen5 bumper. Or be too narrow for the width of the car, etc. Hopefully this makes sense.

I'm putting dual exhaust on my gen5 v6 camry and am modifying the bumper and am looing for other options to accomplish that clean look.

Thank you all for your time.

[b0r1cha]

definitly not going to be a fit unless u do a LOT of custom fabrication

[DrewsCam]

if you got the money it will fit

[cntower]

ya i know it will take a lot of custom fab but i can adapt it to fit on as long as the overall 'length (from rear wheel well all the way around back to other rear wheel well) is the same. That's what I was wondering but I guess I'll just have to try and find someone to let me get down on their car with a tape measure, lol

[gdanaher]

Find a junk yard bumper that is damaged so you can play with it, but without massive fiberglass work it isn't going to work for you. Just don't spend much money.