Lunas2 & rydr1, I’ve tested both bulbs, they’re good.
_Yes, the new OEM stalk (P/N: 84140-33200) has Fog lamp switch position.
There is a 20-pin connector (but there are only 8 wires) plugs into the (stalk) switch control,…. Do you know which one for which?
3-Black (parking light – I know this one for sure, because I installed it for alarm).
Wires going to aftermarket Fog light:
-Right side- Red and White/black
-Left side– Yellow + White/black.
_I used paper clip and jumped: 3 & 4; 8 & 9, and others…. None of them turned the Fog-lights on.
… hope I didn’t get the wrong switch…. Has anyone successfully (or unsuccessfully) installed Fog light with this OEM-Switch (P/N 84140-33200) before????
You are reading the connector wrong.
The correct order is:
20 = pink = Head Light on
19 = green (dark) = DRL (Auto)
18 = black = Tail (Park)
17 = red = High Beam (Flash)
16 = white = Jumper between Fog function and headlight function (may not be there, could be inside switch)
12 = white/balck = chassis ground
11 = light green = Head light (High Beam)
4 = violet = Fog Lights (OEM relay pull down)
3 = white = jumps to 16 (same as 16)
This info was found in Overall Electrical Wiring Diagram (M page 448)
Tie 4 to 12 for test.
NOTE: The taillights / parking lights must be on to have power to the coil to activate the fog relay. (High Beam / Flash is supposed to turn them off.)
Thanks for the info on the stalk. I have not installed this in my car yet, but have checked the prints against the car. (just short of the switch connection plug.) I am holding off on this mod because of hesitation problems.