Toyota Nation Forum banner

2007 SE Rocker-Can bend be pounded out?

748 views 0 replies 1 participant last post by  acousjim 
#1 ·
Something hit my right side rocker and bent the lower part, which caused it to crack. The crack is only a few inches. I'm wondering if I remove the rocker would I be able to push the bottom of the rocker from the backside to make it flush? Below is a picture of the crack.

http://www.flickr.com/photos/84603007@N08/7741285086/in/photostream
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top