Dangling Exhaust Pipe

[_VVTi_]

today i was following another gen 3 camry, and i've noticed something. that gen 3 have one of their exhaust pipe that bends towards the ground, as if it looks like it's gonna scrape the ground if it goes over any big bumps... isn't that a bit dangerous?
does anyone notice that?

will a custom exhaust fix this issue? or will any exhaust do the same thing as this is how camry was designed to be?

[Your Uncle Moe]

I got the SAME exact prblem. I even pointed it out to Luistol and Zoni Camry at our last TN meet. I have had no time to get down there to see what I can do to fix the situation. Sometimes I hear it scrape the ground when I drive over a purtuding manhole.

[Nick]

its not all of them, probably a broken hanger somewhere in the middle

[_VVTi_]

okay, cool i probably should i get it checked out then right?
but i notice it on lots of gen 3 camry haha

[EKam]

Stock Gen3s are all like that.

New catback with new hangers will fix it.

[war0827]

i thought all camrys have that mid section which bends down real low? I check out every camry i see cause i scaped mine alot when i lowered it a while back and almost all camrys had lower bent piping than other sedans.

[Mosquito]

I see it on lexus cars also, though not as obvious, on camry gen5 it looks even lower than on a gen3..some weird design by toyota, must be good for something

[Nick]

mine dosen't hang like that, and its still the original exhaust...

i would have ripped it off a long time ago if it hung like that

[Eye8Pussies]

mine used to, then got the catback, hangers were fine lifted the piping, hit and got stuck on an island=now hanging again

[brungold]

yea ive seen them on all gen3s.. weird

[Xevuhtess77]

my pipe hangs low too, i think its just stock design.

[TheMajesticking]

Yeah. Just like eye8pussies said. I got a catback exhaust and it doesn't bend towards the ground like that now. The stock pipe did though just as all of the gen3 camry that I've seen do.

[97KaMuRi]

my gen 4 got's that problem and i looked under the car the first muffler got a ton of dents in it.

[Mighty~Mart]

i noticed it also... although when i went to the mechanic and saw under the car the piping goes under this thin bar between the rear wheels.... and i though to myself... how much closer could i get my exhaust pipes so that it wouldn't scratch....

ah.. i dunno

[_VVTi_]

but is the low-hanging pipe dangerous? it won't come off if i hit a bump or a deep pothole right?? i'm worried that if one day i go over a bump or a deep pothole w/o noticing it and it would snap off hahah...
so a new custom exhaust will fix this problem right? with like a straight through exhaust?