Cant get door panels off

[94killercam]

Hey, I can't get my freakin door panels off so I can rip out my stock speakers. I had never messed with it before until now. I am trying to install some pioneer rev speakers with tweeters. Please help before i bust something.

[camry_bassss851]

You can buy a guide from crutchfield that shows you exactly how to remove that to install front speakers..its like 5 bucks.

this off topic, but do you have 6 speakers in your car? (front, rear, and tweeters)
Cus i need to upgrade my front speakers, but im not sure if it will cause my deck to have a too small of an ohm load...do i need to remove my tweeters if upgrading my stock speakers?
thanks alot, and sorry for interupting your thread

[Brujo]

Eh, I think it'll help out if you guys tell us what gen Cams you have.

[camry_bassss851]

Mines a 2000 toyota camry LE....

[prnc_chrmng]

if its like my 92, theres 2 screws up front (near the hing) 1 behind the door handle cover, 1 behind the tweeter on the arm thing, 1 above that little map compartment, and one or 2 under the door, other than thats its just a couple of clips holding it in...

[94killercam]

It's a 94 gen 3

[Camry_rider]

Two screws behind two covers *where the door closes* two in the arm rest *one behind cover* one down by the pocket *pry out with flathead* Two push in clips *rear end of the door *push in and pull out* You must unclip the door handle casing, push the door panel in around the top of the casing and pry the top clip up *should be where the door handle comes to an end. Pull it twards you, pull out the door handle and pop off the bottom one *pry down* pull it out and go around the door panel pulling on it to get all the retainer clips off. Very very easy 5 min job when you know what your doing.

[prnc_chrmng]

Originally posted by Camry_rider
Very very easy 5 min job when you know what your doing.

and when you never put all the screws back

[Phi]

http://www.toyotanation.com/forum/t52226.html