Amp placement

[da_horse]

Hi
i was installing an amp into my gen2 (1989) camry sedan and i don't know quite where to put it. eventually i put it in through a hole above the tyre arch that goes through to the side door (im in australia so it's the passenger door i.e leftside) an then through the lil rubber cap near the bottom of the chassis where the door is (but not on the door, the pillar where it hinges) and the though to the rail under the car door.
is this good because im worried if i go through water it might get wet.

another question has anyone put rca's down the middle of a gen 2 yet or just down one side?

Thanks



<font size=-1>[ This Message was edited by: Da_HoRsE on 2002-07-01 02:44 ]</font>

[camryLI]

I havent seen the inside of a gen2 , but i can tell you to try to plac the rca's and the remote wire down one side of the car and the power down the other. less distortion this way. you should be able to pop out the plastic molding near the door sill with a flat head screw driver. hope that helped

[91camryDX]

See if this helps at all.

http://www.toyotanation.com/viewtopi...23&amp;forum=2

[da_horse]

Thanks guys, helps, just that the door rails are getting a tad bit crowded!