ELPrototypes 3SFE cold-air intake groupbuy!!!

[userlain]

I just got back the email I sent from ELPrototypes and they are discounting the 3SFE Cold air intake $20. The final cost will be $160+shipping.

Here is what is in the kit:
Tube #1 Throttle body to back of MAF
MAF adaptor
Tube #2 Front of MAF adaptor to filter ( goes through the fender )
3 boots with clamps
K&N filter

http://elprototypes.com/web%20pics/8...y%20intake.JPG

We need at least 6 people who will commit to this:
userlain

[alex86]

would this work on gen2 engines?

[JetspeedCamry]

3SFE is a Gen 2 Engine!
(If you have a 2VZ (V6) it won't)

[alex86]

damn that sux. damn my 2vz.......o well

[userlain]

Originally Posted by alex86

damn that sux. damn my 2vz.......o well

The throttlebodies are in the same position on both engines, so I think it will work.

[JetspeedCamry]

I'm not sure about that userlain. The position of the piping and airboxes are different. Because this is a complete new unit, perhaps it may work on the 2VZ, however it may require some modification.

[SmokingTires]

It won't fit no matter how close they look. Two different engines, two different piping setups. It wouldn't be worth $160 to find out it doesn't match the engine.

[powderblue91]

this would be so much easier than a custom setup

[EKam]

Originally Posted by userlain

The throttlebodies are in the same position on both engines, so I think it will work.

Try properly measure the diameter of the TB instead...

[JetspeedCamry]

^Thats what I was thinking. Isn't the 2VZ TB input diamter bigger. I know the piping looks quite a bit bigger.