Cloth to Leather Swap - Manual to Power Adj?

[5spd V6 ClrTail]

I'm thinking of getting the leather seats from this 92 XLE for my 92 SE. The XLE seats are power, i have manual adjustments. How will i get everything to work?

[leasaunce]

1st of all you need $$$$. then just a matter of connecting them all up

[5spd V6 ClrTail]

The leather seats are free from that XLE, i know the owner. the car's dead or atleast he's not goin thru the hassle of fixin and sellin it, cuz he has a new Sienna. I need to know if I need the running tracks or will they fit right in to the tracks in the SE.

[chronoti]

take the seats in all, your prolly gona tear up the inside pulling out the wires and stuff for them power seats as well.

do a diy while you at it.

[leasaunce]

im not sure......we dont have the Sienna in Australia. but if the running tracks doesnt fit the camry, you always can modify it


but i believe that most toyota cars have the same length n width regarding the running tracks. (I'm might be wrong...)

[Eye8Pussies]

I would say that the easiest way to do this would be to make sure you take all the rails, etc as well with the seat, and then take everything out of yours and bolt it in...that way you don't have to worry about too much besides for hte wiring

I wouldn't think that the wiring would be too complicated though- it's most likely just wired to a relay of sorts....or perhaps directly to the fuse box, as the power seats always work, even when the car is off.....then you can do the same thing and just hardwire it

[skewe]

as they all said above,

take the rails, and everything that is on the seat. do not strip the leather down cos' it's gonna be tougher to do so