I'm Gonna Try "ACTIVE"....

[bigloubumpin]

In the morning I'm going to try & tackle this new adventure.Today I got my delivery of my new Silver Flutes( http://www.madisound.com/cgi-bin/ind....4651&pid=1078)mids from Madisound,they going to be paired with the ID NX30 tweets I already had.For processing I'm going to be using the Alpine 9813 3-way internal x/o's.The only thing confusing to me at this point is,what should I do with the amps' x/o's?...Should I set Channels 1/2(front) & 3/4(rear) to Hi-pass?...or..Should I set Channels 1/2(front) to Hi-pass for the tweets & Channels 3/4 lo-pass for the mids?.....Any suggestions will be appreciated.

[sq_camry]

if you have a separate xover from the amps, then you will want to disable the amps xover if you plan to use the separate unit.

[cam2Xrunner]

Yeah just turn them off. Just be sure to have the crossovers set properly in the headunit before you reattach the RCA's, (or just keep the volume at 0 ) lol

If your battery dies, make sure to either pull out the RCA's or turn down the volume as soon as you turn the car on.

[bigloubumpin]

thnx cam

[lucanhookup]

how do i turn off my amps crossovers???? i have a alphasonik pma2075a. i cant see any switches to turn them off.......

[sq_camry]

is there a switch that says pass? if so, set it to pass

[Stealth]

usually says full pass/pass through or off

[bigloubumpin]

I think they mean Low-pass/Hi-pass or Full

[sq_camry]

right, full pass pretty much defeats the xover on the amp