Got remote start working...sorta

[UTVols]

I just installed a Viper 5904 remote start unit in my 07 Tacoma this weekend and everything works flawlessly except for the fact that the remote start takes 2 (sometimes 3) attempts to start. For example, this morning I hit the button and I can hear my truck outside turning over the starter for the full 4 seconds of the 1st attempt. Then it tries again and fires right up. It has NEVER fired on the 1st attempt if I let it sit for more than 10 minutes. The only thing I can think to look into is maybe the tach learn didn't do right, but I'm still not sure about that. Seems to me if it's going to always start up on the 2nd attempt, what is it about the first attempt that doesn't want to work?


Sent from AutoGuide.com App

[CriticalAudio]

Starting the 2nd time is the fuel left over and ignites. Just set it to a higher tach or different setting,

1. Try reprogramming tach make sure the truck is cold.
2. Change back to the default Voltage detection mode"low". I leave most vehicles on this setting.