Recently I put some thermozite in my car. And i can feel the difference, but i still want more. Can i put it in the A pillar, also i will put some in the headliner. I also think that mor can go into the firwall, but i think i would have to rip apart the dash for that.
I Put some in the rear footwells.
Almost everywhere i put a layer of edead v1se underneath. Except for the driver and passenger footwell and the firewall. Im not too sure how much that will help. Because im pretty happy with the noise level when the car is idling but when on the highway etc i want it to be quieter, which i think is not a fault of the low end freqs. So more thermoizte or what?
__________________
98 V6 XLE
Dell 5100|SB Extigy|PPI DCX 730|NEXT 4.00|Monitor 2.70|ED Nine.1|LPG 26||Alpine Type R|ED 11ov2's and some other junk
Did you put some on the floor? Under the seats? The roof will help, make sure to apply some edead there too. A pillars couldn't hurt.
Also another part of the car that will help is the outer door skin inside the doors. But you will want to use a closed cell foam like ensolite for that because of moisture.
Did you put some on the floor? Under the seats? The roof will help, make sure to apply some edead there too. A pillars couldn't hurt.
Also another part of the car that will help is the outer door skin inside the doors. But you will want to use a closed cell foam like ensolite for that because of moisture.
yea i put some on the floor. Not any under the seats or what not, seeing as I only ordered 2 yards(24 sq ft) thinking that would be overkill. I looked at getting the inner door panel off and am kinda bewildered on how to get it off.
But all thats gotta wait. Going on vacation for 2 months(no its not nearly as good as it sounds).
Keep me updated on how yours goes. Are you going to do some edead v3 or similar?
__________________
98 V6 XLE
Dell 5100|SB Extigy|PPI DCX 730|NEXT 4.00|Monitor 2.70|ED Nine.1|LPG 26||Alpine Type R|ED 11ov2's and some other junk
I got a gallon of edead v3 so I'll be using that on all the door panels as well as the rest of the removeable interior panels, like the a pillars and back wall panels, etc.
I'll be using ensolte foam, or neoprene if I can find it for the rest of the truck.
Oh yeah, I'll be matting the hell out of the truck-Everywhere. I'll be going with raammat though, I want to use a Butyl based deadener. I have some eDead v1.se left over from my friends install that I'll be using on the floor, but the rest of the truck will be raammat, and edead V3 where I talked about.
Man I got so many bills, it cost's me just in car payment and insurance alone 825 bucks a month Then I got Rent, Utilities, gas, food, etc. Like 2k a month just in bills and living expensive. If I would have kept my old camry, I would have a baddass system in there.(well I did, but it would have been better )
My old camry had the Pioneer AVXP7000CD 7" Flip out monitor/CD player, with the AVMP8000R Brain, XDV-P9 6 Disc DVD Changer.
The front speakers were Infinity Kappa Perfects wired active off a JL 300/4. I had 2 JL 12W3's powered off a JL 500/1, rear speakers until I pulled them out were Pioneer Rev Series Coaxials. The ENTIRE car was matted using Raammat60, and ensolite foam.
I had the Playstation 2 hooked up, as well as a TV tuner, and Alpine XM
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.
ToyotaNation.com is an independent Toyota/Lexus enthusiast website. ToyotaNation.com is not sponsored by or in any way affiliated with Toyota Motor Sales, USA, Inc. The Toyota, Lexus and Scion names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.