Toyota Forum banner

All User Customizable ECU Options on 2010 HL Base W/Out Smart Key

29K views 21 replies 10 participants last post by  funman1  
#1 · (Edited)
So I decided to snap screen shots of all the options available in the Customize Menus in Techstream.
If you don't see a screen shot for a menu item it's because my HL does not have those options so the menus in there were empty.
No point in taking empty screenshots.

Hope the helps someone. Wish I had access to a FULLY loaded HL to get all the options cataloged for people.

The Settings seen here are AFTER I changed my vehicle. These are NOT Factory Defaults!!!!!


Main Customize Menu
Image



Wireless Door Locks
Image



Illuminated Entry
Image



Light Control
Image



Door Lock
Image



Power Window
Image



Warning
Image



Option Setup
Image
 
#4 · (Edited)
In MY vehicle this is all the EASY factory customizations. Again I have a BASE model, so MANY options are NOT available to me.
If I had access to a fully loaded vehicle then I could show you ALL there is, but I don't so.....

If you are up to reflashing eproms on the ECUs then you can change just about anything you can dream of.
However that's not my brand of tea, so you will have to look elsewhere for instructions on that :)
 
#6 ·
I too have the base model (2014 LE). When I lock the windows from driver door, kids in the passengers cannot open or close the windows, which is as expected and designed. Except that the driver side is also locked out. So I have to unlock and then roll up or down.

I was wondering if this is the same on your car? Also I didn't see anything in the ECU to enable disable such (?)
thanks!
 
#7 ·
Really?!? Thats odd, I tried mine and im pretty sure I still have control of atleast both front windows when they are locked. I will double check later.


Woops, just noticed were in the 2nd gen forum. I followed a link and didnt even bother to see where we were.
 
#10 ·
I enabled all three options in Power Window. I get no response at all from holding the key in lock or unlock in the driver's door, and none of the windows (including sunroof) move when I hold unlock on the remote. The only difference I observe is that with the feature enabled, holding unlock on the remote makes the vehicle beep after a couple seconds, right about when the windows should be starting to go down. If I turn the feature off, that beep doesn't occur.

So it's almost like one subsystem (wireless remote receiver?) is signaling correctly but another subsystem (window controls?) isn't behaving, perhaps because it's turned off along with the vast majority of the car when the ignition is off. Maybe there's an extra fuse or something that needs to be installed to make this work?
 
#16 · (Edited)
The OBDII port is above where your feet are. Between the bottom of the lower dash and the heater duct facing straight down. Not on the steering column...or at least on US models.

You can unplug the port from the metal bracket its on and reposition it so its not pointing down with something in. Its what I did as I have a bluetooth adapter plugged in 24/7 for my phone app.


Found an old picture, yellow box is where it normally sits, blue box is where mine is now. Obviously mirror the image side to side since yall drive on the wrong side of the road :D
Image