Went to this Mega Pick and Pull this weekend in PA. I scored a bench seat from a GMC pick up with an armrest. Got it in with minimal fabrication in less than a half an hour. I had to swap rails cause the doner rails were an inch short and the front had 2 mounting holes off center instead of 1. The downfall is the seat belt receiver just makes it through the seat. I'm kicking myself for not getting the seatbelt hardware from the GMC. Let me say it is a BIG improvement from the original springy bar in back seat. This one has about 6 inches of padding so when I hit the bumps I don't get sprung out of my seat.
Forgot to upload the pic's but I'll follow up later.
Here is what it looks like
http://shim1.shutterfly.com/procsser...k0asxupCf2NU58
Linear Mode
