Replaced MAF @ 1700 hours and went for a test drive.
Pleased to report the CEL did not come on ... for about 2 minutes.
So - back to the drawing - I mean scanning - board.
*************
- 7/27 - Start Correction*******************************
Sensor & bank were misstated:
On scanning the various sensors with new ProScan 4 scanner (
www.myscantool.com), found that O2
bank 1 sensor 2 (downstream) was putting out a total of 0 volts, while
bank 1 sensor 1 and bank 2 sensor 1 were putting out around .6 volts.
Very suspicious!
I'm guessing my problem is with the
downsteam O2 sensor.
*************
End Corrections *******************************
Stay tuned.
(Inputs invited.)
Don
P.S. Way to go, Tiger!
