3SGTE swap qns...

[Aaagogo]

Hi guys, after having my baby and the clip sitting in my garage for such a long time, i'm ready to start...

as of now, i'm goin to work on the electrical stuff 1st..

take the hardest out of the way...

1st Qn... in celicatech, their BGB has the electrical component locator pdf files... i printed out the 5th gen and the 6th gen pdf files

but the 5th gen is a LHD and the clip is a RHD.... anyone has any idea where i can get the 5th gen JDM/RHD ECL information...

thanx.

here's the sample of the pages

http://www.celicatech.com/imagearchi...h/ELECTRIC.PDF

http://www.celicatech.com/imagearchi...%20locator.pdf

[3SGTE@daSpeedof]

go to 6gc.net, they have a swap section that will give you the best guides, come back, and post up pictures when your done.

make sure you change your oil seals. Timing belt, water pump, before you drop your motor. Easy way to do your wiring would be to cut a hole in your firewall right behind where your ecu is it only needs to be about 2"high x 3" wide, or you can extend each individual wire 33" long(very long and tedious, cut one wire, extend then soider one wire at time)

[Aaagogo]

yeah, i'm goin to replace everything and anything that can be replaced... goin to get the entire toyota engine rebuild set... hopefully that will cover all the seals and gaskets..

read up on 6gc thousands of times... the BGB section in celicatech right now is most informative as i'm looking and learning the locations of the main stuff...

thanx for the tip on the firewall....

do u know where i can get what i need though.

[3SGTE@daSpeedof]

basically they are exactly the same, you won't be able to find a jdm diagram in english. You have everything you need to do the swap, pull the motor, and get all of your seals changed then. Go from there. Pm me if you have any questions.