4th gen 3S-GE with 3rd Gen 3S-GTE Internals - Toyota Nation Forum : Toyota Car and Truck Forums

Noojra · 01-20-2007, 05:44 PM

Hi guys this is my first post.

I just wanted to know if i could use the Rods and Pistons from a 3rd Gen 3S-GTE in a 4th Gen 3S-GE Beams (Altezza Engine), also could I use the crank or would the stock crank be good enough?

I was thinking of using a Toda kit but i dont think it comes with rods and I dont think the stroker kit is worth the extra 200cc plus its way too pricey.

Thanks

camryfour · 01-24-2007, 11:13 PM

You know that the 3sgte pistons have a lot less compression right? It would only seem logical if you were going to use force induction on the beams, but then again why would you mess with a factory safe 200+ hp daily driver engine by adding force induction? Btw, I have no idea if you can use them together, I was just adding my 2 sense

.