celica 300zx /

[celicagtmatt]

could i fit a 300zx engine in the 1990 celica

[Deep]

Sure, got $20 000 lying around?

[Blane]

yea chop the front end off of a 300zx (the whole end) and weld it to the celica. $5,000

[celicagtmatt]

ok thanx i liek the hole saveing money thing but i have a nothere ? does the 3sgte have a turbo and is it awd or fwd cuz i got the fwd and im not sure if the 3sgte is fwd or awd

[Deep]

Alright.

If you spend 15 mins reading through this forum and use the search button located conveniently at the top of the screen for ease of use, you'll answer your questions. In fact, you'll answer questions that you'll have after you've found the answers to your first questions.

We're here to help, but take some initiative and learn. It gets very tiring answering the same questions over and over.

And www.howstuffworks.com is an awesome site if you're just getting started learning about cars.

Good luck dude.

[T(ra)-VIS]

the 300ZX had a inline 6 and its RWD. you would have to basically use part of the body from the celica and part of the 300. I still dont know if it would work because the front end of the celica is probably too short for the 6 cyl and since celica's are FWD there probably isnt room under the car for the tranny, drive shaft, and rear axle. If you are planning on doing it on an older like a MK3 or older then why bother. Just buy an old school supra. One cool thing I did see a couple weeks ago was a celica around last 70's in like mint condition, jacked up a little and had a big ass V8 in it. I'm guessing its most likely a chev 350 since those are so common and I know the fit in older toyota trucks. The car had big exhaust with dumpouts right infront of the back wheels. It's still not side pipes but still some bad ass lookin exhaust.