turbonetics ct-26 upgrade

[The1andonlyDave]

I'm pullin my old 5sfe out and puttin in a brand new motor. the new one hasnt had any fluids put in it yet. its that new. i plan to put a ct-26 on there without any mods to the new motor except the ones required for the turbo. if i opt to send the ct-26 off to turbonetics for the t3/t4 hybrid upgrade, will i have to up the internals to my motor seeing as how the turbo can push 30 psi and can run to excess of 350hp out of the motor. i know my injectors will have to be changed along with my fuel pump, but as far as the bottom and top-end go they should be allright, shouldnt they?

[Wraith]

I go with either a www.extremeboost.com GT25R or GT30/CT26 combo. Or you could just go with either a www.extremeboost.com GT30 or the KO Racing GT30 Street Brawler kit ... the GT30 you must have the tunning and the street mods to accomodate the turbos....

[MRQtwinturbo]

an upgraded ct-26 will not be able to push 30psi....any more then 16psi and all it will be doing is blowing hot air....

[The1andonlyDave]

Originally posted by MRQturbo
an upgraded ct-26 will not be able to push 30psi

If i push 16 psi then will i be able to run that high of boost with the stock internals

[MRQtwinturbo]

what block are u using??....the 5SFE was not designed to run boost...if u plan on turbo'ng that motor...u will have to go with forged pistons....if ur using the 3SGTE motor....stock internals should be good up to 300rwhp.....i'm still running stock internals with my set up....(t3/t4 hybrid)....