Its all about the numbers!

[ThaChosenOne]

Got my care dyno'd today....its a 91 n/a with an iceman cold air intake, custom headers and exhaust and im pushin 176hp at the rear wheel..i still need to install rockers, pistons and a new crank...my goal is 250 without a turbo...whats everyone else runnin?

[Piddy]

NOT BAD!!! I dont know... haven't got it dynod yet.

[MRQtwinturbo]

never dyno'd yet either....but best guesstimate with butt dyno....and a 108mph.....i'm guessing close to 300rwhp with current setup.....with a built bottom end and cams....i should be in 400 range in a few months.....

[Ratko]

Whoa.. whoa... 176 HP at the wheels on a 5SFE with just intake, headers, and exhaust??

That doesnt sound right at all.

[TeamTRJ]

tahts impossible, i put on custom intake and custom headers and i was pushing 131 tq. and 105 hp to the wheels....now its time for my 3sgte set-up

[JekylandHyde]

The only way those numbers make sense, is if you are talking flywheel HP.
There is no way 91 NA MR2 made 176 wheel hp with intake/exhaust/header.

[Piddy]

NA??? I must have read this wrong. On a turbo... not NA. Lets see the sheet.

[allmotor2]

is ti a 3sge???? stroked?


ickes

[toyotaspeed90]

that's way off..... my ae92 (though it's heavier) has beat a 6th gen celica with a 20V in it... which is faster than the 6th gen GT (5s-fe powered).... and i'm pushing all of 109.6whp with my smallport

no way a 5s-fe is making that kind of rwhp with just simple i/h/e... those are rated like 130 crank hp from stock.....

[ThaChosenOne]

Sorry for the mistake i meant at the fly-wheel but im havin a lot of problems with my engine and might swap