Bed Divider For Sale - Toyota Nation Forum : Toyota Car and Truck Forums

jhobo4 · 06-08-2006, 07:14 PM

For Sale 1 Bed divider. Please pm me if you are interested.

I can`t use it because of my cover and the rail but it is in excellent condition.

Toyota model.

GTCOMA · 06-08-2006, 10:02 PM

So i guess it does not fit with the access cover you have. That sucks. I installed the Bed extender earlier today. It works fine. Maybe if you install the L mounts on the end upside down with the knobs on the bottom it would work. It might be a little tricky to get the divider in the first time, but I think It might work. I feel bad it does not work. Here is a picture of one of the mounts upside down.

***cam2Xrunner*** · 06-08-2006, 10:17 PM

Post a price, as per the For Sale forum rules....

Reason I say that is cause I gotta move this there later on after it's gotten some views over here.

jhobo4 · 06-09-2006, 05:01 AM

Quote:

Originally Posted by cam2Xrunner

Post a price, as per the For Sale forum rules....

Reason I say that is cause I gotta move this there later on after it's gotten some views over here.

I am asking $160 plus the shipping for the divider

Quote:

Originally Posted by GTCOMA

So i guess it does not fit with the access cover you have. That sucks. I installed the Bed extender earlier today. It works fine. Maybe if you install the L mounts on the end upside down with the knobs on the bottom it would work. It might be a little tricky to get the divider in the first time, but I think It might work. I feel bad it does not work. Here is a picture of one of the mounts upside down.

I tried it both ways and because of the cover it wont work.the cover sits behind the rail pushing it too far forward.

jtrovato · 06-09-2006, 02:27 PM

So I'm assuming this won't fit with a Lorado cover?

jhobo4 · 06-09-2006, 04:52 PM

Quote:

Originally Posted by jtrovato

So I'm assuming this won't fit with a Lorado cover?

the cover I have sits behind the rail and that made it stick out too far.The divider is great and I could probably modify it but I don`t want to do that.

jtrovato · 06-09-2006, 04:54 PM

Yeah, I think your cover goes on the same way as mine does, you take the rail off, put the cover's rail on and then install the factory rail over it. That's too bad, I was hoping to get one of these some day. Anybody know how hard it would be to modify it to fit with a Lorado cover?

Pb · 06-09-2006, 05:16 PM

YOu would also have to cut it and make it shorter. When you install a tonneau that mounts underneath the bed rail system, the spacers will move the rails closer to the middle of the truck, which would mean that the bed divider would be too wide, unless you cut an inch or so off of each end.