need help with system

i got a 92 camry. i put ina ponieer reciever from my old car. i have a sony explode amp 760 watts. i but i dont know how to run the power wire through the firewall.if any one knows how please help.

Find your accelerator or speedometer cable coming through the wall and punch a small hole in the gasket and go, go go

thanx for the help ill try that later today

find the grommet hole by your left strut tower in the engine bay. when you run the cable thru there it ends up in the front left wheel fender well. to operate in this area it may be easier to remove the wheel altogether. remove the splash guard. you'll see the rubber boot that you can poke a hole thru to access the interior cabin. it'll pop out by your dead pedal underneath the dash. from there you can run the power cable to wherever you want.

make sure you protect your cable properly to avoid fraying. use wire loom in exposed areas and grommets where the wire goes thru any sharp edged holes.

*i knew i should've taken pics when i did mine!*


-rayray

i think that sounds better than the other idea but ill look around and see which 1 is better ill tell u guys how it went. thanx