Toyota Nation Forum banner

Recent content by Karpov

  1. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Thanks! I looked only 4th gen info but seems like 2004 is pretty same!
  2. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Thanks! I did not find install position. pictures and shop manual either. So i turn it now upside down and its good. Or if its worn i replaced. How sensitive it will turn by fingers if ok?
  3. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Its installed this way both sides:
  4. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    And strut bearing goes this side up when you hold bearing plate in your hand? Because you can install bearing "upside down", red flange down to bearing plate.
  5. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Only option is faulty bearing even its new and torqued like manual says
  6. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Here is video which shows that spring is doing that noise. Cv joints are new. This makes noise even turning car in park.
  7. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    You mean bearing? Red colored. Its new also
  8. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    In this post i tried to say that i replaced rubbers :) In first post they were old but now only old parts are spring and upper plate
  9. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Upper and lower insulators are new
  10. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Is my bearing right side? Not upside down? New it is and quality.
  11. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Now i looked strut when my friend turned wheel. Spring jerks when turning wheels. It can see by eye. Bottom of spring is not moving its place. Upper bearing does this? Its new but faulty? Torque is right.
  12. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    100miles were quiet, i did all kind of turns etc. Now it started again. Im little bit angry now. What it can be? It has to be strut based problem. Spring is old but wont do noise drivers side. Maybe i try swap springs right to left.
  13. 97 camry irritating clunk noise in front

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Im sure that i found problem. Tie rods were fine. I replaced spring isolators lower and upper. I regonized that shock nut is turning 360deg when tightening (same thing was first time). I looked holes at shock and upper plate but i dont know what went wrong. Now it wont spin 360 if i hold...
  14. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Sway bar bushings are 10k old, shocks and bearings with plates new, coil springs and insulators old. Sway bar links new also but noise was before and after. Outer cv joints new (this week) inner tripods etc good. Reason to renew joints was broken boots.
  15. 97 camry and irritating clunking noise when turning

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    I got new insulators in next week. Voice comes outside but video can confuse
Top