Search Results for ‘2nd gen’

Has anyone had issues installing a transmission skid plate (steel) with car guards? I somewhat have everything installed, but two issues. Can’t figure out how to tighten one carriage bolt, the forward bolt on the drivers side. The bigger issue; the rear of the cover is hitting the two lower...

Attempting to remove the alternator's infamous "3rd" bolt/bracket, I was expecting a 12 mm nut. However, what appeared to be 12 mm hex head nut quickly stripped (got rounded) and there was no traction on 6-point socket. Close up videos of the area shows stripping but instead of screw threads on...

I'm looking to buy an AWD sienna. I have found a 2nd gen (5 hours away, I live super rural), the owners tell me that the rear driveshaft u-joint broke, so they removed it and drove 60 miles in fwd without the rear driveshaft connected, before the transmission started to slip. Then they had it...

Getting my ol girl back snuf. Need a lil help with the rear swaybar. Is it the same as the sedan? Anybody have one?

Hi everyone, I just bought a 2013 toyota Highlander Base plus. It came with only one key and no keyfob. I was wondering if anyone knows the FCC id for the keyfob, I would really appreciate that. Side note: I purchased keyfobs from ebay with no luck (using techstream). Thank you so much

Hello In need of opinion if possible 2014 2wd Tacoma Blowing hot air and loud screeching from belt. Took into Toyota dealer. They diag as bad compressor and will comp the belt , oil change & diag. Total at $1800 for repair. Parts installed but they found a restriction in the expansion valve...

I bought a 94 4runner that had neen sitting for almost 8 years. It has its issues, obviously. Right now I am trying to figure out how to fix the driver door not unlocking from the outside using the key. When using the key on the passenger door it works and unlocks all doors, except rear door...

Hello, this is my first time posting I’m just looking for some help making a decision. I know a friend who runs inventory for a large dealership/company. He recently got a 2010 highlander sport with 220,000 KM. It was a repo car so it was a little bagged and needs quite a bit of work. But I can...

I just traded up to a 2011 Sequoia Limited and need to transport an item with 2nd and third rows folded down and “gap flaps” in place also. The load needs to be tied down to keep from tipping over. Are there any tie down points besides the two at the very back? I’ve looked all over and can’t...

Giving my thread a bump here. f*ckin truck.. new OE engine mounts, tranny mount, spark plugs, air filter, exhaust flange gasket, pcv valve, cleaned the throttle body around the butterfly valve, cleaned o2 sensors. when left to sit a minute at operating temp the truck idles at around 600 rpm...

Hello all, I own a 2012 highlander with the standard A 2.7-liter four-cylinder engine, and about a year ago (around 110,000 miles) I noticed that it began to burn a lot of oil between oil changes. The car has always been meticulously maintained, always used full synthetic Mobil 1 oil, never...

Hey all, My OEM bed extender was either stolen or left somewhere by my family members and no one is fessing up. Looking to replace it with another. Brackets are already installed, literally just need the actual extender and don't want to pay $250 for a brand new one. Thanks in advance!

I've currently got a group 24 in my '75 longbed and I know I've had other group numbers previously that also fit but I can't remember them. Maybe we can get a list of all known group numbers that fit for us that will grab up a used battery on the cheap... What kinds do any of you all have in...

Feeling pretty dumb asking this, but how do you go about removing the engine harness on a 2nd gen 3sgte? From what i can see you have to remove the intake manifold to get the obd off? basically what i got is a jdm 2nd gen 3sgte sitting with a cut up harness, and a usdm 2nd gen 3s with a...

Hi there, I have a 1991 Camry, 4 cyl, automatic, about 201,000 miles. I know from reading this forum, that many others have had the same issue, but there have been many different solutions to different problems involving the same thing. I am hoping to determine what the specific issue is with...

i have a 2000 avalon and the grille is not very attractive. ive been trying to find a mesh or billet grille for it but can only find aftermarket grilles for the 3rd gen. i havent been able to see one in person but in pictures it appears as though they are similar in shape and possibly size. I...

OK. So I'm looking to upgrade from my stock air intake to a short ram in my 2000 Avalon. As if finding parts for this bad boy wasn't hard enough, it also happens to have a twin t/b. :facepalm: So if there's anyone out there that could point me in the right direction, maybe even throw a few...

Okay, since there's not too many folks on here with this system I decided to do a quick write-up about it. I've had this kit (aFe Part No.49-46002) for just about 2 weeks now, and I am really pleased with it so far. I think it goes perfectly with the Pro-Dry S CAI I just installed about...