Well I have and mr2 91 5sfe and the engine can’t be fixed. I was wondering if I could put a rebuilt 5sfe meant for a Camrys of the same decade does it matter if it’s automatic or front wheel drive. What I’m trying to ask will I need any extra parts if it’s possible?
Recently did timing belt and water pump change on a 99 solara with 5sfe 2.2, after completing everything seemed fine drove nice and idled good then suddenly while driving car began to drop rpm to zero then return to normal before finally showing zero on the gauge and only moving under idle and...
Hi there, I have a camry with the 5sfe and manual transmission, there is a strong shudder / vibration when taking off from a complete stop, to overcome this you have to peg the revs up to around 2500rpm before taking off,
So far I have checked the engine mounts, replaced the rear and torque...
1996 Camry LE, 2.2L 5S-FE
When I turn the car off, I get a quiet, pulsating, buzzing sound that resembles the sound of a tree branch contacting power lines but on a very small scale. It only happens for 30 to 60 seconds after the car is turned off. It seems to come from these two little round...
Been reading and researching for years, but finally decided to register.
95 Corolla DX w/ 240k
01 Celica GT w/ 140k
97 Camry LE i4 w/ 118k
Maintain for family members:
01 Avalon w/ 150k
08 Tacoma w/ 115k
10 Corolla S w/ ???k
12 Highlander w/ 20k (still...
I have P0325 on my '98 Camry with a 5sfe. Is the knock sensor connected to the block water jacket? Chilton says, when replacing the knock sensor, to drain the cooling system first. Is any gasket used? Chilton says that new sensors have sealant on the threads but there is none on my new one...
I've tried to do as much digging on this as I can and I'm coming up empty right now. Here are the facts:
-97 Camry 5SFE California Emissions
-P0171 code recently popped up
-Air Fuel ratio sensor replaced with Toyota part, that is no longer suspect
-While driving the engine can sometimes surge...
Got a 5S real cheap the engine has about 200,000km (120,000 miles) it appears to have been well taken care of. I pulled the head off it looks good but the cylinder walls have a bit of pitting due to rust. The engine has been sitting for awhile possibly outside for at least some of the time. I...
I have a complete 5SFE engine that was fully rebuilt less than 3k miles ago. Crank turned .010 & .010, bored .020, decked .010, head milled .010, new oil pump, water pump & plug wires, valve job, new timing belt & tensioner. Runs real strong, and doesn't leak anything. Grandson totaled the car...
I was reading how to remove the intake from the head of a 94 camry 4 cyl 5sfe engine.
It is easy but it takes a lot of steps, what caught my interest was the wiring harness.
I disconnect all the conections in the back of the engine(the tranny side).
Then the air horn, the bracket and the egr...