Toyota Nation Forum banner

clutch

  1. Clunk on and off gas at speed.

    Corolla 7th Generation (1993-1997)
    So I recently bought a fairly good condition 5spd 97 DX from my friend and overall it runs and drives great but it clunks from the drivers side when I’m taking off from first as well as when I get on and off the gas while cruising. He sold it to me that way and said it might be the axle so I...
  2. '99 Camry LE AC clutch spinning SLOWLY when jumped, not spinning at all when not jumped.

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Hi all, first post here! So I recently bought a 99 Camry, no AC but for cheap. Here are the symptoms: -Hot air blowing from vents -Blinking "AC" light when depressed on control panel -Compressor clutch not spinning at all Here is what I have done: -Checked pressure in low pressure line...
  3. 87 4x4 pickup shifting problem

    Pre-88 Toyota Pickup/Hilux
    I recently bought an 87 4x4 pickup with 190k miles , and over the past few days I’ve Been driving it and everything has been running fantastic. Last night I drove it to someone’s house and put it in 1st then turned it off. Nothing strange, then about an hour later I get in the truck to go home...
  4. Clutch making noise

    Camry 5th and 6th Gen '02-'11, Solara '04-'08
    So, I have a 2002 Camry manual transmission and when I’m accelerating from a stop on a hill my car is making like a high pitch rubbing noise. It only does it for a second when I’m engaging the clutch in 1st gear. It almost always when I’m on a hill. I’ve attached a link to a video of it. Please...
  5. 1992 Toyota Camry Clutch Question

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    I have a question regarding the clutch in my Camry. At low speeds, the car can tend to "buck" back and forth, almost bouncy but not vertically, its horizontally. It mainly does is while doing about 15 in a parking lot. It also Tends to have a clicking noise almost like two pennies being slapped...
  6. Grinding noise upon trying to start, just replaced clutch < 200 miles ago

    Corolla 9th Gen/1st Gen Matrix (2003-2008)
    As the title indicates, I have an 06 matrix that turns over but won’t start, and a grinding/ clanking noise comes from the flywheel/ clutch area, clutch has a bit too much play and I don’t think it’s the slave cylinder as it moves the shift fork just fine. There’s fluid sprayed on the drivers...
  7. 2007 Camry with Clutch Engagement Issue

    Camry 5th and 6th Gen '02-'11, Solara '04-'08
    My 07 Camry has been having some issue engaging gears on a cold start, I replaced the bushing because it had play, however, it still has the same amount of play afterwards, should I try adjusting it as there is an adjustment, if so what's the spec so I don't over adjust it. There's an inch...
  8. How an Automatic Transmission Works - Full teardown!

    General Discussion
    Here's what's inside an automatic transmission and how it works! This transmission is from the RWD G35. All of its internal components are located along one axis, with no countershafts, since this is mounted longitudinally. This is the transmission pump: The first planetary gear set on...
  9. Toyota Highlander Weird AC - Requesting Second Opinion

    Highlander 1st Generation (2001-2007)
    I have a 2004 Highlander V6 (Base/2WD) with 120k miles. The ac runs fine in town. Recently, however, it has started acting up on long distance / highway trips. After approx 3 hours / 200 miles the ac stops blowing cool air and eventually blows air at room temps. It happened twice: around 4 pm...
  10. 1992 Tercel shift/clutch issues

    Tercel, Paseo, Starlet, and Sera Forum
    Hello! New member here, I’m stumped on my 1992 Tercel and am looking for advice. I have a 1992 tercel with 5e-fe engine and 5 speed trans from an unknown year paseo. But assume around 1992. I’ve driven this car for two years and it has been an amazing little car. I drove to work like any other...
  11. 2000 4Cyl Manual Trans: Question about clutch release fork

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Hey guys! Been awhile since I've been active on here. Anyways, I picked up a 2000 4 cyl 5-speed a year ago. It's been driving great until recently with a vibrating clutch that drooped half way down. I thought it may have been the clutch master and slave cylinders, so I replaced both. Thought...
  12. 03' Echo Clutch cable help

    Yaris/Scion iA, Vitz and Echo Forum
    Hey guys, Could really use a hand here :| I'm trying to do the clutch on my echo, HOWEVER i cant get these clips off the cables for the life of me. any suggestions? I cant find anyone documenting the process on an echo at all.
  13. Bought '07 Auris - please help me fix my mistake - TCS / VSC light with clutch

    Corolla 9th Gen/1st Gen Matrix (2003-2008)
    Hi there, I'm hoping someone out there has some familiarity with this problem (I can't find any solutions online so far) I have recently purchased a 2007 2.2d T180 Auris (or Corolla mk9 I have learned by joining these forums!) and I have a problem! I've trawled the net for the last 2 weeks for...
  14. Help repairing transmission

    Tacoma 1st Generation (1995.5–2004)
    This is on a 1999 Tacoma 2.1 L, 4 cylinder, 2 WD, manual transmission. Today when I was leaving work, I noticed the truck was having a harder and harder time accelerating. It was taking about 1000 more RPMs to get moving to the next gear. When I was on the freeway, it started dropping in speed...
  15. Everything new, clutch pedal still sinking

    Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    1999 toyota camry v6 with a 5 speed manual. I've been fighting this car for a week and the clutch pedal STILL sinks. New Master Cylinder New Slave Cylinder No leaking lines Couldn't afford the Accumulator so I did a bypass Pressure feels a lot more firm but only builds up half way. When I press...
  16. Engine revs up when I clutch in while still cold

    Corolla 10th Gen/2nd Gen Matrix (2009-2013)
    Hi everyone, I just signed up here hoping you can help me figure out what’s wrong with my car so I will get right to the point. My 2013 Corolla ce manual transmission had been running great until recently when it started acting up. When it’s cold (sub-zero Celsius) my car idles high (between 1k...
  17. Aftermarket Pressure plate, stock disk?

    MR2 Forum
    Hello, My 3VZ-FE MR2 N/A with a S54 (Stock N/A trans) came with a clutch masters aftermarket clutch. I believe it is the FX300. I found out that the disk was worn out but the pressure plate is OK. for budget reasons, I don't see myself buying the Clutch masters disk for 300$. Will an oem disk...
  18. 1992 Paseo belt squeal hard to track down - much details inside

    Tercel, Paseo, Starlet, and Sera Forum
    Hello all - not my first post here, but I am pretty new. Got a 1992 Paseo with 109,xxx on the clock [supposed junk yard motor swap with cluster, car supposedly has about 30k more on it] I'm at 117,xxx now - the cam/crank seals and timing belt were supposedly changed before I got it, I just...
  19. What's inside a Torque Converter?

    Corolla 8th Generation (1998-2002)
    The torque converter is located between the engine and transmission on most vehicles with an automatic transmission. It is responsible for connecting the engine to the transmission. Here's a video on how it works: The torque converter sits in the bell housing in front of the transmission...
  20. clutch pedal with no resistance

    Tacoma 1st Generation (1995.5–2004)
    About a month ago my clutch pedal went soft and spongy and it was difficult to get going in first gear or reverse. The truck was drivable by pumping the clutch and shifted fine once I got going. I replaced the master and slave cylinder myself but wasn't sure about the clutch pedal adjustment or...
Top