crank

I have taken my vehicle to a Toyota dealer and a mechanic and no one seems to be able to tell me what the problem is they can’t find it. My car starts fine in the mornings cold starts or even if it’s a hot day. But always starts in the morning when our problems. The problem starts when I drive...

Car died while driving. Towed it home and checked battery voltage. 7.6V - yikes! Replaced battery, car turned right on and checked voltage again running. 12.3-12.2. Checked continuity from Battery to alternator and it was good so replaced the alternator. (sucked). Now car will crank but not...

My girlfriend recently bought a 2014 Yaris and for the most part it has been a great car for the value, but the window crank handles are just awful. Is there any aftermarket replacement, or window crank handles from another car I can get from the junk yard?

My 2001 Echo was running fine. I did some simple body work that might have involved removing and inserting wiring connectors. I have been back over it and think I plugged most of them back in :-) Anyway, I tried to start it and got no crank, no click. I noticed that, when I turn the key to...

i have a 95 tercel that when i turn the key, i hear the fuel pump and it lights up but wont turn over or start. I parked it back in february due to the transmission jumping out of 4th gear. It still drove and cranked fine then. I cranked it and drove it around my yard periodically and then one...

Ok so I've recently run into a no start issue. As I was driving on the freeway, everything fine, until suddenly I hear a loud popping sound coming from the engine bay, initially killing the engine. And after taking a look under the hood I see that a wire additionally connected along with the...

87 22r very light tap in the bottom end so I drop the pan pull bearings one shows very little copper so I figure I'll just throw some new bearings in std size as what were in it. Now I can't turn the crank even w a breaker bar. Torqued caps to 42 ft lbs I'm thinking I got my caps mixed up. They...

Ok so I can crank the car long enough for about 30 minutes and the car will finally turn over, idle a bit rough for a minutes as I rev up the engine then it will run fine while the car is nice and warm, if I shut off the car I can also start it up just fine as long as the car doesn't sit for 3...

Hey guys im new here, I got a 03 Corolla LE with 158,000 miles in December. Ever since now it's been running fine no problems even in this crazy cold weather (New jersey). Recently it's been giving me a real hard time starting. On a cold start like if I leave it overnight and start it in the...

Sometimes when I start my car it makes a weird cranking/grinding noise for half a second. The closest thing I have to engine mods are my TWM short shifter, and my borla axle back exhaust. The noise only happens after my car has been sitting there, parked for a few hours. So to bring it to...

Brand New Unorthodox Racing Ultra S Crankshaft Pulley for a 83-91 Camry 2.0L/ 86-99 Celica 2.0L/2.2L and 96-99 Rav4 2.0L. I think the engine is the 5SFE but I could be wrong. Asking $100+shipping via Paypal. :)

I'll start with the basics. The car is a 1992 Camry, 2.2 L 5S-FE engine, automatic tranny. The car has about 215k miles. A couple of days ago I couldn't get it to start, it would crank over nicely, but no start. I left the car over night in the parking lot and came back the next day to being...

I'm in the middle of a timing belt change on my V6 and am a little stumped that I can't get my timing marks to align. The FSM says if the cam markings don't align when the crank marking is aligned to turn that cam a complete 360 degrees (thats because the crank has 24 teeth and the cam has 48)...

I've got the transmission out to replace the friction in the drums, should I go ahead and replace teh crank bearings just because... say just because I'm removing the balance shaft assy? I have no noise in the bottom end and no reason to suspect journal egging, I was thinking a standard set...

Dear all, I am a new driver. My 2001 Camry has an automatic transmission. I would like to confirm the following steps to fully protect the transmission. Start: 1.Switch key to ACC 2.Apply brake pedal 3.Start Engine 4.Still apply brake pad and switch to 'D' or 'R'. 5.Release parking brake...