Search Results for ‘cv axle’

I have a 1997 Celica with a body code of E-ST202-BLPZF. I already know some stuff like the suspension and front brakes are different but I want to know if other parts like the CV axle is interchangeable between my car and the USDM Celicas.

I have a 96 t100 sr5 4x4. The boots on the CV axles are ripped and they clunk on sharp turns. The truck's steering is pretty loose and there is a wobble at higher speeds. Basically I would like to do a bit of a front end overhaul and am wondering what folks would suggest I replace while I have...

Has anyone here had any experience with replacing or pulling out a CV axle on a Toyota 2018 or newer? Mine will not come out of the transmission. I already know about using a pry bar and even a slide hammer. Before I set out to buy a slide hammer, is there something new they did with it to lock...

Hi all, first time posting here looking for advice! I have a real head scratcher. I have replaced the transmission on my 2007 matrix xr (man. 5 speed) with a tranny from the junk yard from a 2008 corolla. Everything has gone back together totally fine and I was about to celebrate when I got...

2005 toyota camry 3.3l 5 speed auto driver side axle will not come out. I have pretty much all suspension components removed aside from the sway bar, so i have lots of room to work. I have bent multiple pry bars in an attempt to wedge one in and pry the cv axle out. the cv axle strangely moves...

Hi, I have a 2005 Camry 3MZ-FE 3.3L I have recently been troubled by my driver side axle and hub bearing. Long story short, I needed a new hub and axle, so I went to the junkyard and got an axle/hub assembly from an 03 Camry. I installed the axle and noticed it was still dripping fluid down the...

I just replaced the rear bushings on both front control arms on a '92 Camry 2.2L XLE FWD, and while putting everything back together on the right side the knuckle pulled on the CV axle and may have pulled either the inner joint out of its "socket" or the entire assembly out of the transmission...

Howdy, I have a 2004 Toyota Camry XLE, 2.4L with about 210,000 miles. Today I was pizza delivering in the ole reliable, tuggin' along just fine when on my 3rd drive, I noticed the transmission was jerking in first gear near the torque band when I was accelerating. I didn't notice it in 2nd or...

Hi all, I am in the process of replacing the CV axles on my 2009 Highlander LTD, 3.5L Gas AWD. And I'm kinda stuck. I started w/ the driver side. The dis-assembly went fine, and I was able to pry the CV axle out. All good. Then, when I removed the driver-side axle, a lot of fluid drained...

Hello everyone. 2003 manual 5spd here A few months ago I noticed an oil leak, which was dripping down onto the bottom of the transmission, by the drain plug. Today I jacked the car up and looked around. The entire back of the transmission is soaked in oil, and the leak appears to be coming...

Hello everyone! I just found some liquid by the manual transmission drain plug. Followed it upwards and the spot where tranny and CV axles meet is where it stops. Maybe not where it stops, hard to see up from there, it got dark. I wiped it all with a paper towel. It didnot smell like the...

What now? Any way to re insert axle back into the transmission ‘without damaging the tri pod’ as mentioned ~ 4:25 in this video or should I follow instructions for ‘CV axle replacement’ disassemble, re install 2004 VG XLE 105,000 miles 1mz-fe This is my 1st post, Question, Cry for HELP YIKES

Hey all. I recently replaced both my cv axles and that went super smooth but like a lazy idiot I didn’t replace the seals and they started leaking right of the bat. I figur snit would be easy to just pop off axles replace seals and throw the axles back on and be good to go. PS came of just fine...

I have a 2004 Camry Se 3.3 the front end has started to have a wobble at highway speeds. it has 135000 miles on it. Could this be the CV axles?

I bought a used car recently with 20K miles on it and took it to Toyota service center for pre-purchase inspection and came to know of rust issues. The car has been in Ohio (cold/snow/salt exposure) for the past few years with no issues mentioned. The following are the issues mentioned: 1. Break...

I have a 2005 Toyota Highlander, FWD, 4 cyl, automatic, 244k miles, original owner. I have a noise which I will describe in a minute but first some info on recent work done so you know where the car stands. The noise existed BEFORE I did these things. New complete strut assemblies all around...

I made a short video explaining what’s inside a CV axle and how it works to power your car’s wheels: Here are a few photos of the breakdown. The CV Axle contains the inner joint, which slides and swings slightly, and the outer joint, which can swing to extreme angles. Pop off the boot That...

I've narrowed it down to the CV joint on my 2012 Camry LE. Once we got it jacked up I moved the tire like it would if you were driving, and there is the clicking noise. That tells me it's at least the inner CV joint (I think?). I'm fairly confident I can change it myself, however I am having a...

So, I'm not much of a mechanic when it comes to Toyotas- most of my experience has been with my old Mustang- and have never replaced a CV axle on any car. My father is going to be helping me with this project, and we were just wondering if there were any tips or advice we might find useful?

I'm having an issue with my wife's 2008 Camry. We're feeling vibration at highway speeds. Feels like it's coming from the front passenger side. We've had all 4 tires replaced (two of them replaced twice because we got lucky and the shop gave us a set of 4 for free with all the trouble we were...