Search Results for ‘engine mount’

Hello. So it was about 3 months ago or so I got my matrix 2005 xr. The issue with it was that I found it vibrating a lot and it’s pretty obnoxious sometimes. I bought aftermarket motor mounts and it still vibrates, and that’s when I did more research and found that aftermarket mounts don’t help...

2001 A/t Base 4dr sedan 1.5L 1nzfe TLDR#1; For the rear mount, should i replace the whole bracket assembly with the damper/insulator as well as the mount? TLDR#2; For the trans mount, Is damper/ insulator required on A/T 1. Cat went bad within 1 year so my 1st guess was motor mounts, replaced...

Car: 2003 Camry 2.4 LE, over 200K mileage. I have new brakes, new struts assembly, new tie rods (Inner+outer) in short the front end suspension all new parts. But for some reason I hear gentle thumping noise when I hit a speed bump left and right. All bushings in front end were also replaced...

Hi everyone, I have some vibrations while in park and while in drive. Not really in neutral though. It sounds like the exhaust system is vibrating against the car, but I was thinking that it could be worn engine mounts. Are there any other suggestions as to what it could be? If it is the mounts...

Guys, I am trying to replace the rear motor mount on my Camry, but having a real hard time removing the top 17 mm bolt. I tried to use a breaker bar as leverage to an 17 mm wrench from the bottom but the nut does not budge. I also tried from the top using a 3/8 inch "U-joint" but the U-joint...

I have changed most of the ignition components, but still have a vibration when stopped and in gear. Its a little worst when AC compressor is on. I have changed a couple of engine mounts -- "dogbone" and the one right at the front. Changing the one at he front with a non-OEM made things worst...

I have a 2005 Camry I4 2.4 liter automatic. It vibrates a lot at idle, and possibly in drive as well, but I can't tell because my wheels have been off balance for so long that I can't remember what it used to be like. When I purchased this vehicle some years ago, the torque strut dog bone mount...

Neither can my mechanic. Any suggestions? It's an 89 Celica GT 3S-FE Automatic built in 02/89. I appreciate any help. :)

Hello, the car is a 2004 Camry LE 2.4l. I have been posting about a slight vibration when starting the car and in reverse and decided I'd start a new thread now that I think I've found the issue. I'm worried my motor mounts are going bad. Visual inspection makes it seem like they're good but...

i got an 06 corolla s, was curious if any vendors sold motor mounts, maybe even trans mounts. my engine is really shaky at idle. was just curious on pricing and where to buy em from. thanks all.

Well long story short engine blew up on my girlfriends 2002 Toyota Camry 3.0. After calling Toyota and asking around here I was told that the 1MZ-FE engines in these things are pretty much all the same as long as it does not have the VVT-i. I ordered a long block from J.I.S. that they said...

I'm tossing the option in my head of going with the front mount in the link below or just going all out and paying $98 for the OEM one...

Hello all. I just finished replacing my rack/pinion (aka "steering gear" according to the Hayne's Manual) in my back yard today. It wasn't much fun, as I don't have a lift, but I am living proof it can be done. I searched extensively here at TN forums and other places across the web, as well...

Just got a 91 DX Wagon Automatic trans and it starts up and runs very nice, but when I am in gear and come to a stop a vibration occurs from the engine compartment. I can feel it in the wheel and on the brake but only when i make a complete stop. Its totally smooth idling in park or in neutral...

1993 Camry LE 5SFE, since I bought the car there has been a front end knock. It happens over larger bumps and rough roads. Sounds like it's coming from the right front of the car. I've replaced the following since I've had the car: Struts, springs, mounts (all 4), front and rear sway bar...