Search Results for ‘gasket’

2009 Toyota Tacoma Prerunner TDR 2WD Engine 4.0L 236 hp V6 Access Cab Model: ACP Body Type: PC My FIL and I have been working to replace some knock sensors using the methods explained in this TRQ video. I was finishing up when I found this gasket laying on the ground under the truck. It...

93 t-100. Been sitting for about a year. I solved one problem thru this site then quit. I went to work on it this week and it started fine then jfked rough. I don't think the gauge works right because it has never showed hot. Anyway I checked dipstick and found nothing unusual... Just a little...

Hi all, My 06 Limited's rear right door has a piece of rubber seal that rotted away and fell off (photo #1 and #2). My rear driver's side is still intact for reference (photo #3). Does anyone have experience replacing this part? I'm having a lot of difficulty finding a part number. This...

Hello all, I have just a general exhaust leak question. Recently my 1997 4cyl. Camry began exhibiting an exhaust leak coming from the front of the engine where the manifold is located. I have not run a test to see exactly where that leak is coming from but just due to the sound am confident...

I drive a 2003 Toyota Corolla manual CE, about 260xxx miles on it. I recently noticed that the bottom of my car is leaking and I recall the leak coming from the bottom of the passenger side, around the left tire, and somewhat in the middle. At first I figured it was just the AC condensation from...

I learned a couple things from a UT video. 1. Whoever installed the kit didn't install the standoffs for the engine cover and instead carved up the cover to fit. 2. The instructions supposedly say to take the gasket off of the original filter to put on the new filter. There is no gasket...

I bought a used 2015 Highlander V6 from a Toyota dealer and the kilometer was at 123,000 KM. At 172,000 KM the head gasket blew had a leak, the 2015 Highlander V6 has the 2GR-FE engines. Is this an issue with these engines?

Im planning to swap my 2E to a 2EE. What are the main differences other than the fuel injection method? Does the carburated 2E gasket kit fit the 2EE? (obviously without the gaskets for the efi stuff)

03 4runner 4.0 l v6. When cleaning the inside of the valve covers with non-chlorinated brake cleaner and a non-metal bristle brush, some of the gasket material (FIPG maybe?) from that riveted plate on the inside of the cover started coming off, not huge chunks, they were only about 1/32" in...

2009 Camry LE overheat/possible gasket blown after state inspection done. I may seem log winded because I'm trying to have everything down that just occurred fresh on my end. Link of the video: Background about the car and events that have taken place: -2009 Camry LE 4 cylinder -Miles...

So I am having a head gasket oil leak in my vehicle repaired in a few weeks. As part of a pricing deal, I am gathering parts required for the job and currently stuck at what type of FIPG to get for various points; Valve Cover - ? Timing Chain Cover - Seal Packing 1282B-Toyota Silicone Liquid...

(Scion TC 2006)... Long story short I striped the oil plug trying to make the oil change on my own. Lesson learned, won't happen again... anyway, I managed to get it re-threaded but the plug is leaking, and I hate it. I want to change the oil pan and gasket. Problem now is removing the pan...

I'm sorry in advanced, this is going to be long... Backstory: I created this account for this issue alone and believe me, I have been lurking around this forum seeking a similar thread for about 6 months since I got the 1989 Toyota Corolla (4AF) at the beginning of this year and although this...

Anybody have this problem? It is not from burning oil. We tested the compression of each cylinder, it was ranging from 135psi-155. Car has about 295km, and its leaking from the right hand side. I tried a few sealers and the best one, rislone concentrated main sealer repair was temporary. I...

Hi All, I have a 1993 Corolla 1.6L that is leaking quite a bit of oil around the timing cover. I know I will need to take it apart to find the source, but wondering if anyone else has experience this and what caused it - crankshaft seal, oil pump?

2003 Corolla 175k miles 2 days ago car started running real rough and the CEL came on and was flashing. I pulled the codes and got P0303. This happened a few months back with P3031, I replaced coil #1 problem solved, so I ordered a coil again. Today I go to do what I assumed would be a 5...

So ive heard some say on here that if/when you swap the valve cover gasket on this car you should also check the valve clearances. I have very little understanding of this, but I do know how an engine head functions so I bet I could figure it out, but any tips on what I need to do or what I...

here it is, enjoy: http://youtu.be/SKec-VNbh7s