Toyota Nation Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

21-31 of 31 Results
  1. Corolla 7th Generation (1993-1997)
    Hello, I have a 97 Base Corolla w/o a clock. I would like to install the stock clock. How can I go about this? I've been to auto junkyards and pulled out the front part but I have no Idea how to pull out the wiring. I have no experience with cuttin wires or anything electrical lol. Is it...
  2. RAV4 2nd Generation (2001-2005)
    Hello, Having a very difficult time trying to connect the amp to the battery. Cannot see any way to get through the dash. I would appreciate any input as I cannot drive my vehicle at this point. I can provide pictures if necessary. Please help!
  3. Avalon 1st Generation (1995-1999)
    I am installing a Kenwood DDX319 I also bought a Metra 88-00-8000 Toyota Pocket Use with Factory Brackets, and Metra 70-1761 Radio Wiring Harness For Toyota 87-Up Power 4 Speaker I have the wiring diagram I was just curious as to if someone can give me some recommendations or assure me...
  4. Corolla 8th Generation (1998-2002)
    Okay so Im new to this forum and im new to wiring up things but i understand the basics and if i have it properly explained to me. So basically what i want to do is install these universal projector fog lights on my 98 corolla and have them switched so they come on when i flip the switch but i...
  5. Corolla 10th Gen/2nd Gen Matrix (2009-2013)
    Hey just wondering if anyone can identify the audio wiring colours, I found this: Battery LIGHT BLUE (+) RADIO HARNESS Accesory GRAY (+) RADIO HARNESS Ground BROWN (-) RADIO HARNESS Illumination GREEN (+) RADIO HARNESS Power Antenna TAN (+) RADIO HARNESS LF Speaker (+) PINK LF Speaker (-)...
  6. Corolla 10th Gen/2nd Gen Matrix (2009-2013)
    I have a stock 2010 Corolla with the standard circle speakers in the front, 6X9s in the back. I bought some speakers that do not have the tweeters built into the woofer for the front speakers so I need some ideas on where to put them, etc. Any pictures of how anybody has done it would be the...
  7. Tundra 1st Generation (2000–2006)
    So I am installing some Bilstein 5100 adjustable height shocks on my truck. The rears were a breeze. The Fronts, not so much. I removed the 3 top nuts, removed the nut and bolt that attaches the shock to the lower control arm, and pulled the shock and coil assembly away from the truck. I...
  8. Corolla 7th Generation (1993-1997)
    My wife drives a 1993 Geo Prizm, and it's time to replace the rear speakers. I don't want to pay a tech $50 to $100 to do this, since I've heard it isn't that hard to do. But I can't figure out how to get to the speakers without damaging things along the way. I've searched the web, and through...
  9. Corolla 7th Generation (1993-1997)
    I have a 97 Corolla DX and a Code Alarm CA-100 I would like to install. I am having problems getting the power door locks to respond to the alarm. There is an OEM alarm system installed but I do not have the keyfob. Could someone explain how to correctly wire this alarm system to open the door...
  10. Tacoma 1st Generation (1995.5–2004)
    Hello all, i have some confusion that is in need of clearing. On the TRD supercharger for the 3.4l 5VZ (2002). What is the purpose of the vaccum pod that sits on top of the supercharger that is attached to some sort of linkage and what does it hook up to? I have the installation guide but it is...
  11. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Thought I might as well post this. Its Quite Easy, but you should use caution while doing this because some parts are delicate. Before I start, note this: I am not responsible for any damages that may occur. I had no problems myself and it is quite easy, however, professional...
21-31 of 31 Results
Top