Search Results for ‘lift’

I was wondering about how I could widen my t100 a bit. Spacers aren't Ideal but I'm not against it. I'd like to widen it enough for the tires to stick out past the fender flares. I don't have measurements I just would like to know what's doable without trimming. I also want to lift it a few inches.

Hi everyone, I'm curious about something. I have installed a 4" spindle lift on my 2WD T, and I'm curious, could I take out the front lower shock mount on my shocks and reuse that into a 4WD shock that is extended to fit my truck? Thanks!

Costco is currently taking $300 off a few of their QuickJack Portable Car Lift Systems until February 21! QuickJack 5000TL Portable Car Lift System - $1299.99 (originally $1599.99) QuickJack 7000TL Portable Light Duty Truck and Passenger Car Lift System - $1499.99 (originally $1799.99)...

I drive a 2002 Tacoma that's RWD. I really want to get a 3-4 inch lift kit but every single kit I see is for 4WD only. Does anyone here have a good recommendation?

Hello new to this forum I was wondering what options I would have to lift my 2003 camry. I want to lift it high enough to put 24 inch rims on. How high would I have to lift it? Thanks

I'm really new here so bash me relentlessly if I'm doing this wrong. I would like to start a discussion about anybody who is running the 2" torq lift or other kits as well as wheel and tire sizes increases that have been done with or without a lift. I've added a picture of my highlander not...

I installed some Coil Spring Specialist custom rear springs in my 16’ FWD Sienna for trailering. I spec’d it out as a 1.5” lift, but ended up with 2.25”. As a result, I occasionally experience rear shock top out. I added a stack of 5/8” washers to the top of the shock which helped, but did...

Hey I have a 95 t100 that is a 2wd and I’m trying to lift the front end more without cranking my torsion bars. I have a 1.5 block in the front already and I was wondering if I could possibly stack two of those blocks on top of each other and get longer bolts to go through them both. It’s hard to...

Our liftgate has been acting up for awhile now. Seems like the motor is getting tired or worn out. Early symptoms included it would close about 1/2 way then reopen. Another button push and it would close fully. Then a year later it would take 2 or 3 times. Now its so tired we just...

Hey Everyone, I have a 2008 FJ Cruiser that needs new shocks and struts at some point. I have been told that there is cupping on my tires 2 different times. I was thinking since I need new shocks and struts of investing in a 3inch lift kit, looking at various brands. That way when I need new...

Hi everyone, I need some advice on diagnosing an issue with LIFT on my car. I have a 03 Trix with 04 motor, the issue is my car lift wont engage. Car revs up to 7000-7100 RPM and then cutoff kicks in, it revs up to 7-7.1 k RPM really smooth but won’t go higher. Now I do have a check engine light...

So I recently decided to get a 3 inch lift on my 05 Tacoma Access cab. Now I currently have Dunlop AT20's on which says P245/75R16. And to be honest, I know nothing about tires. They are on the stock Toyota rims which I don't mind keeping. I'd like to get some new, beefier tires that will look...

So I want to lift my truck, but not too big. I'm looking at the 3 inch Rough Country suspension lift. I don't do much off-roading, so I don't need a crazy suspension and shocks. Any thoughts on this kit? Like I said, I don't do a whole lot of off-roading, just looking to make it a little taller...

Hi all. I am looking for some advice on lifting a '93 toyota pickup with IFS. It's a great little truck. has the 22re in it. 5 speed. I love it, but the previous owner seems to have lowered it quite a bit. It does have 2" lowering blocks in the back. whole rig just sits right on its tires...

I am wondering what uniball control arms are for, I have spacers on my struts which is putting a lot of stress on my upper ball joints they are pushed I almost touching my strut springs and causing my tires to wear on the inside. Any suggestions ?

Hey, I am new to site and looking for advice on how to go about lifting my truck. On monday I am picking up a 8" rearend out of a 1 ton toyota to swap into mine; will add a leaf, longer shackles and mount leafs on top. Doing it as a start to eventually have 31"-33" on it. I am trying to figure...

I am lifting My Tacoma SR5 double cab long bed I have added and aftermarket bumper which weighs 185 lbs i am looking for about 2 inches of lift also Items i am looking to buy WHEACH32-460x400 ADD A LEAF KIT – WHEELER’S 2″ LIFT BILSTEIN 5100 HEIGHT ADJUSTABLE FRONT STRUT SET C477 BILSTEIN...

Is there any strut spacers available for the 7th gen rollas? Or other ones that will work/made to order. Trying to set up a more functional suspension setup for how drive it.

i just bought some xd810's for my 2002 tacoma the size is 20" x 10" with a -24 offset. im going to put 33's on them but i stil have no clue what kind of lift to get. i was planning on going with just a 3 inch but i cant find a good complete kit to buy because they all say that they have the...

'96 T-100 2WD 5-Speed Manual Xtra-cab Sunfire Red 318k and still going strong 2" inch lift. by perf acc. installed with friend 02/09/13 I like it! A/c Still cold. 265/70 r15 bfg's on 15x8's Just waiting to get a Powertrax 92-2080-3002 No-Slip although the wait seems endless, I am going to...