Toyota Nation Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Camry 5th and 6th Gen '02-'11, Solara '04-'08
    I am going to change fuel filter which inside the tank. It has one o-ring for fuel pump and one for fuel pressure regulator o-ring. Do I have to change both o-rings, or can I put the old o-rings back?
  2. Celica Forum
    I have a 3SFE 1997 engine. I've installed a Toga HV oil pump. My engine also has an oil cooler. But when I turn on the engine and accelerate it oil starts shooting out of the oil filter. When I remove the filter it has blown out the filters O-ring. I use 5W-30 since I've rolled it of the show...
  3. Camry 5th and 6th Gen '02-'11, Solara '04-'08
    Hello, My name is Richard and I'm new to the forum here! My fiance's 2003 Camry LE had a radiator gasket blow yesterday. It's the plastic plug with the 6 triangle cutouts perpendicular to the radiator cap and reservoir. It normally threads into the junction/housing, but it BROKE. I don't...
  4. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Bummed my new heater core did not come with new o-rings. Does anyone know what size they are? I'm really hoping they're a common size (ARP, dash size), or a *reasonably-priced* source for them? Plus, I'd like to upgrade to silicone from the (I assume) nitrile material.
  5. Camry 1st and 2nd Gen (1983-86) and (1987-91)
    I have an 89 Camry with a little over 86,000km on it. In late June, I noticed that it was leaking a small amount of oil. 1-3 drips appeared on a piece of cardboard underneath and a puff of smoke comes out the exhaust when starting the car after it has been sitting for 8-12 hours. Anyway, my...
  6. Camry 1st and 2nd Gen (1983-86) and (1987-91)
    I have just bought a sweet 90 camry with a 2.0 4 cyl engine. It has the common wet start problem so I decided to replace the coil. Unfortunately when I was removing the coil the U shaped gasket shown in the pdf link attached broke up. Does anyone know the part number of this gasket or where I...
  7. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    96 Camry LE 4cyd, 5SFE. See image for dist. As oil leak, I am going to replace dist o-ring. According to Haynes and web posts, it should be easy. I followed steps to remove dist cap first then one 12mm screw on dist. I just found only one screw to hold dist. I tried very hard to take dist out...
1-7 of 7 Results
Top