Search Results for ‘oil pressure’

It's a rough time to try and buy a Tundra or Tacoma, I know. Issue: After a mechanic helicoil'd when a plug seized and stripped the threads, warning lights come on until the engine warms up (including high oil pressure). The warning lights will go off if the truck is turned off and on again...

I have a 2005 gen2 RAV4 with 187000 miles. This is my daughter's car, so I'm especially sensitive about it. About a month ago, I noticed a kind of grinding noise at idle and higher that was diagnosed as a bad timing chain. I was urged to replace it by our family mechanic ASAP as it could...

Hi folks. 96 4Runner. Darndest thing. Oil pressure light and seat belt light come on AFTER I turn off and remove the key. I replaced the oil pressure sensor, tried a new ignition switch. Any ideas? No lights while running. The dash lights drain my battery if I don’t disconnect. Otherwise runs great.

Hey guys; i am new around here and new with my 6th gen celica. Lately i have seen an issue when i start the engine. Occasionally i can hear a bang bang from the passenger side of the engine for a few seconds; when i start it. The oil pressure light will stay on until the sound is gone...

Hey folks, I need to know the thread size on my '88 3SGE, thanks

Hello all, I am new to this forum, and looking for some insight. I purchased a 94 pickup a few months ago with around 142,000 miles. I bought it knowing that these pickups sometimes have noisy valves, but would like for anyone with the same model (22-re) to verify that this is normal for...

Hi, I changed oil yesterday at Midas for my Toyota Corolla 2000. It was okay until this evening. Then the oil started leaking and it was a lot of leak. The oil pressure light came on. And, I checked the oil dipstick and there is some oil left. Would it be a oil filter problem? I know I...

The oil light on my 1998 Camry 2.2L (190,000 miles) recently started coming on after engine start. The light will go out if I rev the engine briefly and it doesn't come back on, even while idling. I'm not low on oil, but it is overdue to be changed. Dirty / faulty sending unit? Dirty pickup...

Make : Toyota Model : Camry LE Motor: 5sfe Year : 1994 Mileage: 129k miles Dropped the pan and screen is clean, no apparent sludge in engine. Want to check the high pressure relief valve. Is it testable/removable with the oil pan removed or do I need to remove the oil pump? Problem started...

I need help determining if i have an oil pressure problem, if i need to be concerned, and, if i need repairs at fix. Here are the facts: 1993 Toyota Pickup, extended cab, v6 3vze engine, 5 speed Oil pressure readings taken from certified manual gauge installed in oil pressure sender port on...

Hello all. Im a new user looking for some guidance on my new t100: 97 V6 3.4 manual SR5 w/ ~200k ex cab I got this beauty about 2 months ago and was using for work around town, doing a considerable amount of driving. Everything was running fine and I was starting to get over my old...

Hi, I would really appreciate any advice you guys can offer. My husband was driving our 2003 corolla on the highway today and suddenly the oil pressure light came on (red). He kept on going a couple of km (to reach the nearest gas station) and suddenly the car stopped and would not start again...

Purchased a rebuilt long block, new oil pump, gaskets, ect. Did the swap, no problems. Started it up, red light on. replaced the sending unit with a new one, same thing. Installed a test guage at the oil pressure port, no pressure. So, I think that I messed up the oil pump. The one that came...

ARGH! I LOVE my Highlander, it's a great Mommy-mobile and traveling early intervention OT car! I bought it used in 2009 from a local dealer. However the first week of 2011 has been less than exciting! Since mid-December, tires on driver's side, front and back, leaking air, go from normal...

Hey guys, been a while since i've posted anything on this forum!!. Anyhow, heres my story: Started hearing a rapping noise and it sounded almost like the Rod bearings or Main bearings were going bad. So I decided to check the oil pressure at idle and warmed up to normal temp. I hooked into...