Toyota Nation Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-13 of 13 Results
  1. Highlander 2nd Generation (2008-2013)
    I attempted this approach: However, trying to wiggle out the house was impossible for me. It is a weird location, hard to work there. :-( The video shows well where the PCV valve is if anyone needs it.
  2. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Im currently installing an oil catch can into my car and ive been re adjusting some things with the plumbing of the lines, could anyone advise me on if the pcv valce has to be in line with the allignment tab or if i can rotate it to face a different direction slightly, thanks!
  3. Avalon 2nd Generation (2000-2004)
    I need help / advice please. I have a 2000 Toyota Avalon XL with 284K miles. The car runs well. I bought the car pre-owned at 120K miles. I change my oil every 5,000 miles. I drive mostly highway miles, about 40 miles daily. Recently, I had noticed some oil in my engine air-filter so I changed...
  4. Camry 5th and 6th Gen '02-'11, Solara '04-'08
    Toyota Camry 2006 PCV valve started doing rattling noise after replacement. Link below the one I bought in Oreilly https://www.oreillyauto.com/detail/b/... Cleaned original valve and put it back. Problem is solved
  5. Highlander 1st Gen - Hybrid (XU20/2005-2007)
    I have a 2010 Highlander Hybrid that's on almost 300k km. It's still running great. It's the 2GR-FXE engine (V6). I'm almost certain that a recent increase in oil consumption is due to a broken PCV valve and I'd like to have a go at replacing it myself. The question is, where can I find the...
  6. Highlander 1st Generation (2001-2007)
    Hi, Just wanted to share my experience with everyone here. I bought a 02 highlander v6 AWD on the cheap with 179k miles. It wasn't till i got it home that I realized it was burning about 1 quart of oil every 400 miles. (I didnt see any smoke on purchase) After trying the cheap PCV valve fix...
  7. Camry 5th and 6th Gen '02-'11, Solara '04-'08
    My car is still very good with 244 900 KM. I have noticed oil likely goes fast. OK, here, I did noticed the gasket front area is dark, looks like oily. So I opened the cover, and looked around, the back side is nice, clean, but the front is dirty. I used the socket and screwed those nuts, they...
  8. Tercel, Paseo, Starlet, and Sera Forum
    Hello - My name is Jesse- I just joined today and had a question that i have yet to find any help with thus far... I just bought the car. I have been told and shown docs that the car had a few things done to it. The car runs ok/fine when cold; however when the engine gets warm the car has a...
  9. Avalon 3rd Generation (2005-2012)
    I cannot find the torque value for the PCV valve anywhere. The only information I found seemed to suggest that thread lock or locktite is needed to install. I failed to find the correct torque value in the service manual if it was there. Does anyone know? Is 12204-31040 the right part number...
  10. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Hi everyone, I just bought a 98 Camry LE for my father-in-law to replace his 92. It has 121k miles and its the 4-cyl 5S-FE engine and auto trans. It starts and drives OK, not as good as my wife's 01 with 160k, but alright. I planned on just doing regular maintenance like timing belt, water...
  11. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Hey everyone, I am going to replace my PCV valve in my 99 camry 5s-fe. I was just wondering is there a brand that is best? All of them that I have seen are like $4-$7. What brand is OEM? Does it even matter? Thanks!
  12. Highlander 1st Generation (2001-2007)
    After a wonderful morning at the DMV, I was finally the rightful owner of a nice 2003 Highlander V6. As I drove off, Murphy decided to pull a Check Engine Light on me. I just smogged it yesterday and looked at it up and down a few days ago when I bought it, so I knew there were no symptoms...
  13. RAV4 1st Generation (1994-2000)
    First, I own a 1999 Toyota RAV 4, Manual, all wheel drive. My check engine light has been on for quite a while now and when I scanned it I got the code P0401, insufficient flow of something I forget. The guys told me it could be a number of things one of which is my PCV Valve and Hose, and they...
1-13 of 13 Results
Top