Toyota Nation Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 6 Results
  1. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    This sounds like a simple question, but I'm stuck!! I think that the motor is shot on the motor/regulator unit (driver's side window), but I need to remove the motor/regulator unit to inspect the regulator, and then repair/replace it. However, I'm having a ball of trouble getting the window...
  2. Camry 7th Generation (2012-2017)
    My rear windows, driver's side mostly was stuck...on and off, mostly off...since I bought Kitacamry 2 years ago, and discovered this...(for search engine users the title identifies potential sources for the problem)... The windows were so snug that they stuck to the rubber if not used much...
  3. Highlander 1st Generation (2001-2007)
    Tools: Tape, putty knife, small flathead and Phillips screw drivers, 10mm socket & wrench, and a T25 Torx Tape the glass to the window frame Start by removing the one screw that is located behind the door handle, once removed you will then need a thin flathead screw driver to remove the...
  4. Tacoma 1st Generation (1995.5–2004)
    Hello, I've decided to replace the lock actuators and window motors in my 02 Tacoma. They're fairly anemic in cold weather. I've tried to break the code on the replacement parts for a few hours, and it's possibly more complicated than I thought. 1. Door lock actuators. $75-80 each. But I...
  5. Camry 3rd and 4th Gen '92-'01, Solara '99-'03
    Ok here is the situation. My drivers door window will only roll about a quater of the way down then seems like it runs out of power and just stops. When I hold up on the window and press the button for the window to go back up, it goes about half an inch then stops. A mechainc told me that my...
1-5 of 6 Results
Top