Toyota Nation Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
813 Posts
I have 99 sienna, but take is out should be easy, holding by two screw and left up.

You can purchase new, or get it from junkyard or use JBweld and fix it for $4. There is no pressure involve, so you can take it out anytime. make sure drain empty let it dry and then apply JBWeld.
reservoir gets little hot but JBweld holds well. you can buy 4 minit cure JBweld from orailly, Autozone.

Hope that helps.
 

·
Registered
Joined
·
813 Posts
I am so sorry, i was thinking about radiator reservoir. I think you are talking for windshield washer reservoir. I think pump installed on reservoir might you have leak in gasket. you have work from bottom or passanger side wheel.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top