Toyota Nation Forum banner
1 - 1 of 1 Posts

9 Posts
Discussion Starter · #1 ·
Up for sale is my 1993 Lexus SC300. It is a factory original 5 speed manual transmission car. It is emerald green with tan leather interior. Here is a list of all the performance enhancements and maintainance that has been done:
- 1JZ-GTE 2.5 liter twin turbo JDM spec motor (dyno'd at 303 rear wheel horse power)
- Fully Functioning Air Conditioning
- HKS Front Mount Intercooler S-Type
- HKS Intercooler Piping
- HKS EVC Manual Boost Controller with Computer
- HKS Fuel Cut Defencer
- HKS Pod Style Air Filter
- Wallbro 255 Fuel Pump
- Techniques 6 Puck Clutch
- Kakimoto J-Spec Exhaust With Catalytic Delete (factory cat comes with car)
- Fluidyne Aluminum Radiator
- Replaced All Control Arm Bushings with Rubber Units (preferable over polyeurethane for ride comfort)
- Replaced All Sway Bar Bushings
- Replaced All Power Steering Rack Bushings
- 18" Lexus SC430 Wheels With Twist Style Center Caps (round center caps also included)
- 16" Mark IV Supra Wheels With New Pirelli Snow Tires (staggered fitment)
- Falken Azenis 245/40/z18 Tires
- Bilstein Shocks/Struts
- Bilstein Springs (lowered car 1")
- Toyota Soarer Front Rotors And Calipers (upgraded to JDM spec larger units)
- 2000 Style Lexus SC300 Rear Deck Spoiler With Integrated LED Tail Light
- 2000 Style Lexus SC300 Front Bumper And Grill
- Soarer Front Bumper Emblem
- Soarer Rear Trunk Emblem
- Recently Replaced Interior Out Of Clean SC400 With Heated Seats
- New Belts and Hoses

This car is in very, very good condition. It has some minor nicks and scratches but overall it is an 8 out of 10. The only thing that it really needs is to install the Supra Mark IV injectors that come with the car. Then the fueling will be just right and it will run even stronger. Please call or email me with questions. [email protected] or 914 552 5408. I'll post some pictures soon. Car is located in Brewster, NY 10509.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.