Toyota Nation Forum banner

1997 3.0 liter exhaust repair

813 Views 0 Replies 1 Participant Last post by  Stan54
I have a leak on the joint between the middle section and the rear section on the above.

Have been quoted £500 for Mild steel and £1000 for stainless steel replacement.

Currently using wynns gasket product to seal BUT can anyone suggest an alternative method or kit.

I was considering asking a garage to cut out the joint and then use some sleeving to fix, but all the rapid fit outfits just want to replace !!!!!

What a suprise !!!

The pipes are stainless but the flanges are mild steel, they are the items which have corroded.

Any bright ideas out there please ??

1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.