Toyota Nation Forum banner
1 - 7 of 20 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Does anyone have a file that shows the cabin's fuse box layout. Im trying to hardwire a dash cam and I want to wire it through the fuse box. The link on I found here doesn't work.
 

· Registered
Joined
·
10 Posts
Discussion Starter · #7 ·
If you just want it on when the engine is started, use just the ACC fuse. If your camera supports parking mode then use the ACC fuse for one wire and the DOME fuse for the parking mode wire.

The layout is on the the other side of the fuse cover. If you want to know what each fuse is then go here, Master List of DIY/Tutorials, Lighting/HIDs/LEDs, Fuse...
and under MISC. you'll find the fuse list.
I see the ACC fuse but I don't see the DOME fuse. would it be the same one under panel or no? I do plan on using parking mode on my camera. Its the reason I want to hard wire it. I did get a circuit tester to test which circuits are still live when the car is off. But I want to make sure I don't tap into a fuse for something important like the airbags.
 

· Registered
Joined
·
10 Posts
Discussion Starter · #10 ·
hmm.. is it different for the 2020 model year? These are the two fuses i used for my dashcam. Its the instrument/cabin fuse panel. Also i took a picture of the fuse box.

View attachment 309495 View attachment 309496
I'll have to double check when I try to install my camera. thank you for the pictures though! what amp fuses did you use for the fuse tap? would it be the same amperage as the ones you tapped into?
 
1 - 7 of 20 Posts
Top