Toyota Nation Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
:confused: having some problems getting this thing running
no spark and no injectors firing
did pin out on ecu, injectors had .6v were suppose to have 10-14
i looked over the diagram and i believe i was missing the black/org wire that goes to ignition
so i hooked that up and now have the voltage i need there but still no spark or injectors
checked voltage at the two coil wires and there is voltage there too
any help would be great
thanks
 

·
engineer in training
Joined
·
1,586 Posts
Check all of your engine grounds, thats the easiest place to mess up the electrical system.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
just did a pin out on the igt (ignitor) it is suppose to be .6-1.2v during cranking and its at 6.5v when cranking
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #5 ·
newb mistake, ignitor wasnt grounded well
thanks for the help peoples
it is misfiring a bit though
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #7 ·
there is no wire it grounds through the casing just bolt it to the firewall or somethin bare metal
 

·
Registered
Joined
·
91 Posts
what type of car are you putting the 3sgte in cause i have a 1992 toyota celica gt and i have turboed it and 3 months ago i fried the rings so i was thinking of putting in a 3sgte or building the 5sfe to withstand 300hp+ even though i only need about 250 crank also if you have time call me 843-254-1929 and we will talk about the install ok thanks.......
 
1 - 8 of 8 Posts
Top