Toyota Nation Forum banner

92 jdm swap help!!!!!

965 Views 9 Replies 7 Participants Last post by  Quyen
2
me and a friend swaped a 92 celica with a 1.6 to the jdm 1.6 and when we try and fire it , it runs but rev-hopps like no other?
whats wrong ecu some thing not hooked up? what please help... thank you



See less See more
1 - 10 of 10 Posts
rev hop? please explain the meaning of this, what happens, and when it happen?
I would guess it means the rpms are going up and down. :shrug:

Have you checked for vaccum leaks?
alltracman78 said:
I would guess it means the rpms are going up and down. :shrug:

Have you checked for vaccum leaks?

yes at idle it hops from 1500 to 3500 or so... where can i get a vacuum diagram :)
You could try here. www.celicatech.com
I dont' have one myself.

To see if you have a leak, with the engine running, spray brake cleaner around anywhere you took apart that has to do with the intake system.
Also, try around the vaccum lines.

Don't use too much, it's not good for the rubber.
are you telling us that it runs 3500k without your foot on the gas?
Try adjusting the TPS sensor.
This happened when I swapped a 3sfe for a genII 3sge. Turned out the throttle position sensor was slightly opened.

Quyen
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top