Toyota Nation Forum banner

94 camry remote starter installation

8145 Views 3 Replies 4 Participants Last post by  Kush_P
Hello,
Friend of mine bought remote starter off ebay for $60 came with all the wires and modules and keyfob. Before I go ahead and start working I wanted to get a overview of what I will be dealing with. Anyone have diagrams of the wires that needs to be added to ignition switch ect? Car is 94 toyota camry. Is there a DIY for this also?

Thank you for your time
1 - 4 of 4 Posts
This was written based on putting a remote starter on my wife's Gen 4 Camry (1997), but it should be very similar at least.

http://www.tracystruesoaps.com/tutorials/gen4rs/remotestarter.html

Hope this helps,

Tracy
That's a great write up and I used it when installing mine. As far as starter wiring goes... check out this. The cut wire and 12volt positive wires are what trip most people up.

See less See more
I was wondering why the starter wire is cut. the remote start that I purchased only seems to have 1 wire for the starter, so what am i supposed to do with that? its the avital 4103

➢ Heavy gauge relay wiring diagram
1 PINK (+) (30 AMP) OUTPUT TO IGNITION CIRCUIT
2 PURPLE (+) (30 AMP) OUTPUT TO STARTER CIRCUIT
3 ORANGE (+) (30 AMP) OUTPUT TO ACCESSORY CIRCUIT
4 RED (+) (30A) HIGH CURRENT 12 INPUT
5 PINK/WHITE (+) PROGRAMMABLE OUTPUT FOR ACCESSORY OR IGNITION
6 RED (+) (30A) HIGH CURRENT 12V INPUT
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top